| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 10 |
| Windscreen wiper does not clear the windscreen effectively | 8 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 7 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 6 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
| Rear parking brake recording little or no effort | 3 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 3 |
| Service brake: efficiency below requirements |3.7.B.7| | 3 |
| Parking brake: efficiency below requirements |3.7.B.7| | 3 |
| Driver`s seat insecure |6.2.A.1| | 3 |
| Centre Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
| Offside Front Anti-roll bar linkage fractured |2.4.G.1| | 2 |
| Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
| Front passenger seat insecure |6.2.3| | 2 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Brakes imbalanced across an axle | 2 |
| Rear brake application uneven | 2 |
| Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 2 |
| Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
| Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
| Nearside Rear Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
| Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
| Nearside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
| Nearside Rear Body has a projection caused by damage |6.1.C.1| | 1 |
| Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Brake performance not tested |3.7.A.1| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
| Offside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
| Offside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
| Exhaust tailpipe not capable of allowing the emission probe to be inserted |7.3.B.1| | 1 |
| Parking brake lever has no reserve travel |3.1.6b| | 1 |
| Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Front brake disc excessively pitted |3.5.1h| | 1 |
| Offside Front front brake recording little or no effort |3.7.B.5a| | 1 |
| Horn not working |1.6.2a| | 1 |
| Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Horn not loud enough to be heard by another road user |1.6.2b| | 1 |
| Fuel cap/sealing device does not fasten securely by positive means |7.2.4b| | 1 |
| Nearside Front Track rod end ball pin shank loose |2.2.B.1c| | 1 |
| Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Rear brake binding | 1 |
| Offside Outer Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Inner Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Inner Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Nearside Inner Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Outer Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Headlamp insecure both |1.7.3| | 1 |
| Offside Outer Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Headlamp insecure |1.7.3| | 1 |
| Nearside Headlamp has a product on the light source so that the light output is severely reduced |1.7.5a| | 1 |
| Offside Headlamp has a product on the light source so that the light output is severely reduced |1.7.5a| | 1 |
| Offside Windscreen wiper blade missing |8.2.2| | 1 |
| Nearside Rear Coil spring not correctly located |2.4.C.2| | 1 |
| Offside Rear Coil spring not correctly located |2.4.C.2| | 1 |
| Nearside Rear coil spring modified and seriously weakened |2.4.A.2| | 1 |
| Offside Front coil spring modified and seriously weakened |2.4.A.2| | 1 |
| Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Exhaust system not adequately supported |7.1.1| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Brake pipe excessively corroded | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Centre Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Windscreen washer not working | 1 |
| Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Outer Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Registration plate lamp issues | 1 |
| Nearside Front Anti-roll bar linkage insecure |2.4.G.1| | 1 |
| Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |