MOT History from tests of lpg ROVER 200s year 1998

Review the list of common ROVER 200 failures below or to perform a specific mot history check on your ROVER then use our popular KnowYourCar service

mot history

Pass percent:50.00%

(The average a lpg ROVER 200 year 1998 passes without issue)

Based on:20 MOT Tests

Most common failures	No# failures
Parking brake: efficiency below requirements \|3.7.B.7\|	6
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits \|7.3.D.3\|	5
Exhaust emissions carbon monoxide content after 2nd fast idle excessive \|7.3.D.3\|	4
Exhaust emissions hydrocarbon content after 2nd fast idle excessive \|7.3.D.3\|	3
Registration plate lamp issues	3
Rear parking brake recording little or no effort	3
Offside Front Track rod end ball joint has excessive play \|2.2.B.1f\|	2
Windscreen wiper does not clear the windscreen effectively	2
Anti-lock braking system warning lamp indicates an ABS fault	2
Brake pipe excessively corroded	2
Rear Exhaust system not adequately supported \|7.1.1\|	1
Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings \|6.1.B.2\|	1
Rear Exhaust has a major leak of exhaust gases \|7.1.2\|	1
Centre Stop lamp not working \|1.2.1b\|	1
Nearside Front position lamp\|s\| not working \|1.1.A.3b\|	1
Offside Rear Subframe mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Supplementary Restraint System warning lamp indicates a fault \|5.4.2\|	1
Offside Rear position lamp\|s\| not working \|1.1.A.3b\|	1
Electrical wiring inadequately supported \|1.9.2a\|	1
Battery insecure \|1.9.1\|	1
Centre Exhaust has a major leak of exhaust gases \|7.1.2\|	1
Offside Rear position lamp\|s\| excessively deteriorated so that it is not visible from a reasonable distance \|1.1.A.3d\|	1
Brake hose excessively deteriorated	1
Nearside Front Anti-lock braking system component excessively damaged \|3.4.2\|	1
Offside Front Anti-lock braking system component excessively damaged \|3.4.2\|	1
Rear Lower engine mounting deteriorated resulting in excessive movement \|6.1.D.1a\|	1
Service brake: efficiency below requirements \|3.7.B.7\|	1
Registration plate issues	1
Nearside Front Anti-roll bar linkage rubber bush bonding deteriorated resulting in excessive movement \|2.4.G.2\|	1
Nearside Front Track rod end ball joint has excessive play \|2.2.B.1f\|	1
Rear fog lamp switch faulty \|1.3.1a\|	1
Exhaust emissions carbon monoxide content at idle excessive \|7.3.D.4\|	1
Offside Front front brake binding \|3.7.B.1\|	1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Most common failures	No# failures
Parking brake: efficiency below requirements \|3.7.B.7\|	6
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits \|7.3.D.3\|	5
Exhaust emissions carbon monoxide content after 2nd fast idle excessive \|7.3.D.3\|	4
Exhaust emissions hydrocarbon content after 2nd fast idle excessive \|7.3.D.3\|	3
Registration plate lamp issues	3
Rear parking brake recording little or no effort	3
Offside Front Track rod end ball joint has excessive play \|2.2.B.1f\|	2
Windscreen wiper does not clear the windscreen effectively	2
Anti-lock braking system warning lamp indicates an ABS fault	2
Brake pipe excessively corroded	2
Rear Exhaust system not adequately supported \|7.1.1\|	1
Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings \|6.1.B.2\|	1
Rear Exhaust has a major leak of exhaust gases \|7.1.2\|	1
Centre Stop lamp not working \|1.2.1b\|	1
Nearside Front position lamp\|s\| not working \|1.1.A.3b\|	1
Offside Rear Subframe mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Supplementary Restraint System warning lamp indicates a fault \|5.4.2\|	1
Offside Rear position lamp\|s\| not working \|1.1.A.3b\|	1
Electrical wiring inadequately supported \|1.9.2a\|	1
Battery insecure \|1.9.1\|	1
Centre Exhaust has a major leak of exhaust gases \|7.1.2\|	1
Offside Rear position lamp\|s\| excessively deteriorated so that it is not visible from a reasonable distance \|1.1.A.3d\|	1
Brake hose excessively deteriorated	1
Nearside Front Anti-lock braking system component excessively damaged \|3.4.2\|	1
Offside Front Anti-lock braking system component excessively damaged \|3.4.2\|	1
Rear Lower engine mounting deteriorated resulting in excessive movement \|6.1.D.1a\|	1
Service brake: efficiency below requirements \|3.7.B.7\|	1
Registration plate issues	1
Nearside Front Anti-roll bar linkage rubber bush bonding deteriorated resulting in excessive movement \|2.4.G.2\|	1
Nearside Front Track rod end ball joint has excessive play \|2.2.B.1f\|	1
Rear fog lamp switch faulty \|1.3.1a\|	1
Exhaust emissions carbon monoxide content at idle excessive \|7.3.D.4\|	1
Offside Front front brake binding \|3.7.B.1\|	1

MOT History from tests of lpg ROVER 200s year 1998

Find us on Facebook