| Most common failures | No# failures |
|---|
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 12 |
| Headlamp aim out of alignment | 7 |
| Parking brake: efficiency below requirements |3.7.B.7| | 7 |
| Brake pipe excessively corroded | 5 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 5 |
| Rear parking brake recording little or no effort | 3 |
| Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Nearside Front Direction indicator incomplete |1.5.A1b| | 3 |
| Offside Front Direction indicator incomplete |1.5.A1b| | 3 |
| Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 2 |
| Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
| Offside Rear Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
| Offside Rear Radius arm worn and seriously weakened |2.4.G.1| | 2 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
| Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
| Nearside Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Windscreen wiper blade deteriorated |8.2.2| | 2 |
| Service brake: efficiency below requirements |3.7.B.7| | 2 |
| Nearside Front Obligatory mirror missing |8.1.1| | 2 |
| Nearside Stop lamp not working |1.2.1b| | 2 |
| Nearside Windscreen wiper blade deteriorated |8.2.2| | 2 |
| Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 2 |
| Offside Rear Suspension arm has excessive play in a pin/bearing |2.4.G.2| | 1 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Brakes imbalanced across an axle | 1 |
| Nearside Front Brake lining|s| less than 1.5 mm thick |3.5.1g| | 1 |
| Front Fluid suspension has no suspension movement |2.4.D.5| | 1 |
| Offside Rear Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
| Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Offside Front Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
| Nearside Rear Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
| Offside Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear wheel bearing rough when rotated |2.6.1| | 1 |
| Nearside Outer Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Nearside Indicator tell tale inoperative |1.4.A.2a| | 1 |
| Centre Hazard warning switch faulty |1.4.B.1d| | 1 |
| Nearside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Nearside Rear Radius arm worn and seriously weakened |2.4.G.1| | 1 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Rear Sub-frame synthetic bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
| Offside Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
| Offside Rear Lower Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
| Nearside Front passenger door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
| Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
| Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Front Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
| Rear brake binding | 1 |
| Nearside Rear Suspension arm worn and seriously weakened |2.4.G.1| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Inner Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Outer Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Inner Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Inner Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Offside Front Suspension has inadequate clearance with the chassis |2.4.A.1a| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Vehicle structure is cracked, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Exhaust has a part missing |7.1.1a| | 1 |
| Nearside Front Body has a sharp edge caused by damage |6.1.C.1| | 1 |
| Offside Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
| Nearside Front Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
| Offside Rear Radius arm has excessive play in a pin/bush |2.4.G.2| | 1 |
| Front Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
| Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
| Fluid suspension has no suspension movement |2.4.D.5| | 1 |
| Nearside Rear Radius arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Inner Front Lower Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Inner Front Lower Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Nearside Front Direction indicators not working |1.4.A.2c| | 1 |
| Vehicle structure is damaged, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Radius arm has excessive play in a pin/bush |2.4.G.2| | 1 |
| Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Rear fog lamp switch faulty |1.3.1a| | 1 |
| Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Registration plate lamp issues | 1 |
| Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Front Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength |2.4.A.3| | 1 |
| Nearside Outer Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Front Gas suspension has no suspension movement |2.4.D.5| | 1 |
| Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Nearside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Rear Rear position lamp|s| insecure |1.1.A.3a| | 1 |
| Nearside Outer Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Nearside Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |