| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 4 |
| Registration plate issues | 2 |
| Nearside Front Steering rack gaiter split |2.2.D.2d| | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Brake hose excessively deteriorated | 2 |
| Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wheel arch (6.1.1 (c) (i)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Headlamp not working on dipped beam both n/s and o/s (4.1.1 (a) (ii)) | 1 |
| Headlamp aim not tested (4.1.2 (b)) | 1 |
| Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
| Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i)) | 1 |
| Front Steering linkage ball joint has excessive play both n/s and o/s track rods |2.1.3 |b| |i|| | 1 |
| Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Offside Headlamp insecure (4.1.1 (c)) | 1 |
| Front Headlamp has a product on the lens so that the light output is severely reduced both - condensation (4.1.4 (b)) | 1 |
| Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner & outer (6.2.2 (d) (i)) | 1 |
| Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner & outer (6.2.2 (d) (i)) | 1 |
| Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt severe leakage of grease (6.1.7 (g) (ii)) | 1 |
| Brake lever has insufficient reserve travel (1.1.2 (a)) | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Exhaust system not adequately supported |7.1.1| | 1 |
| Rear brake application uneven | 1 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
| Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
| Nearside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
| Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |