Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 7 |
Headlamp aim out of alignment | 6 |
Registration plate lamp issues | 6 |
Brakes imbalanced across an axle | 5 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 5 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 4 |
Brake pipe excessively corroded | 4 |
Offside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 3 |
Nearside Front front brake binding |3.7.B.1| | 2 |
Fuel cap/sealing device ineffective seal split (6.1.3 (b) (i)) | 2 |
Nearside front brake binding |3.7.B.1| | 2 |
Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 2 |
Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
Nearside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Nearside Front Road wheel fixing loose (5.2.1 (a) (i)) | 1 |
Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Lower Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Front brake application uneven | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Nearside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
Offside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
Nearside Front Front constant velocity joint is excessively worn |2.5.C.1b| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Brake pedal anti-slip provision missing (1.1.2 (c)) | 1 |
Nearside Headlamp insecure (4.1.1 (c)) | 1 |
Offside Headlamp insecure (4.1.1 (c)) | 1 |
Headlamp aim not tested (4.1.2 (b)) | 1 |
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed & corroded (5.3.6 (a) (i)) | 1 |
Nearside Front Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) | 1 |
Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Indicator tell tale inoperative |1.4.A.2a| | 1 |
Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Rear fog lamp tell tale not working |1.3.1b| | 1 |
Rear brake application uneven | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Service brake is causing the steering wheel to severely pull one way |3.7.C.2| | 1 |
Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering inner sill under step |6.1.A.1| | 1 |
Nearside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering corner panel behind rear wheel |6.1.A.1| | 1 |
Offside Vehicle structure has excessive corrosion which adversely affects braking or steering outrigger at front end of rear spring |6.1.A.1| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Brake pedal anti-slip provision missing |1.1.2 |c|| | 1 |
Fuel cap/sealing device ineffective seal split |6.1.3 |b| |i|| | 1 |
Nearside Headlamp insecure |4.1.1 |c|| | 1 |
Offside Headlamp insecure |4.1.1 |c|| | 1 |
Headlamp aim not tested |4.1.2 |b|| | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength strut top area, behind front door hinges |5.3.6 |a| |i|| | 1 |
Nearside Front Wheel bearing play so excessive it is likely to break up |5.1.3 |a| |ii|| | 1 |
Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill holed & corroded |7.1.1 |a| |i|| | 1 |
Nearside Front Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill holed & corroded |7.1.1 |a| |i|| | 1 |
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed & corroded |5.3.6 |a| |i|| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point mount holed & corroded |5.3.6 |a| |i|| | 1 |
Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt |5.3.4 |b| |ii|| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Rear Service brake effort inadequate at a wheel both |1.2.1 |a| |i|| | 1 |
Brake hose excessively deteriorated | 1 |
Nearside Rear Direction indicator not working |4.4.1 |a| |ii|| | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill |5.3.6 |a| |i|| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill |5.3.6 |a| |i|| | 1 |
Nearside Rear Suspension component mounting prescribed area is inadequately repaired spring hanger |5.3.6 |a| |i|| | 1 |
Offside Rear Direction indicator incorrect colour |1.4.A.2f| | 1 |
Offside Rear Direction indicator adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
Nearside Rear Direction indicator adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
Offside Rear Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Rear Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Rear Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
Offside Rear Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
Rear Rear fog lamp not working |1.3.2b| | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Offside Front Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Nearside Front Steering rack gaiter insecure |2.2.D.2d| | 1 |
Exhaust system not adequately supported |7.1.1| | 1 |
Driver`s seat fore and aft adjustment mechanism not functioning as intended. |6.2.A.3| | 1 |
Offside Front Macpherson strut insecure |2.4.G.1| | 1 |
Nearside Front Brake pipe leaking |3.6.A.1| | 1 |
Offside Front Ball joint has excessive play |2.2.B.1f| | 1 |
Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Offside Front Seat belt retracting mechanism defective |5.2.5b| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded inner step |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded inner step |2.4.A.3| | 1 |
Offside Suspension component mounting prescribed area is excessively corroded sill structure |2.4.A.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded inner wheel arch |2.4.A.3| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded inner arch |2.4.A.3| | 1 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |