Most common failures | No# failures |
---|
Headlamp aim out of alignment | 4 |
Offside Front Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 2 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 2 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Registration plate lamp issues | 1 |
Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Hydraulic brake cylinder leaking hydraulic fluid |3.6.A.1| | 1 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Offside Front Braking system leaking |3.6.A.1| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Nearside Parking brake mechanism/associated mounting prescribed area is excessively corroded |3.1.9| | 1 |
Offside Front Parking brake mechanism/associated mounting prescribed area is excessively corroded |3.1.9| | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Sub-frame attachment rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Rear Sub-frame attachment bracket/mounting corroded and its strength is seriously reduced |2.4.G.1| | 1 |
Offside Rear Sub-frame attachment bracket/mounting corroded and its strength is seriously reduced |2.4.G.1| | 1 |
Nearside Rear Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Nearside Outer Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Windscreen washer not working | 1 |
Nearside Headlamp aim projected beam image is obviously incorrect Kick up wrong way (4.1.2 (c)) | 1 |
Offside Headlamp aim projected beam image is obviously incorrect No kick up (4.1.2 (c)) | 1 |
Nearside Rear Exhaust has a major leak of exhaust gases Connecting pipe between boxes (6.1.2 (a)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Floor pan to chassis (5.3.6 (a) (i)) | 1 |
Nearside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Offside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Front Inner Suspension arm pin or bush excessively worn end bush of steering rack (5.3.4 (a) (i)) | 1 |
Nearside Front Inner Suspension arm pin or bush excessively worn end bush of steering rack (5.3.4 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i)) | 1 |
Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt insecure (6.1.7 (g) (ii)) | 1 |
Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split (6.1.7 (g) (ii)) | 1 |
Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
All position lamps not working |1.1.A.3b| | 1 |
Nearside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
Offside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
Brake lever not releasing correctly and functionality of brakes affected handbrake (1.1.2 (b) (ii)) | 1 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Offside Rear Suspension arm pin or bush excessively worn axle bush (5.3.4 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle bush mounting (5.3.6 (a) (i)) | 1 |
Offside Headlamp aim projected beam image is obviously incorrect kick up to right |4.1.2 |c|| | 1 |
Nearside Rear Exhaust has a major leak of exhaust gases connecting pipe between rear boxes |6.1.2 |a|| | 1 |
Offside Outer Steering rack gaiter missing or no longer prevents the ingress of dirt |2.1.3 |g| |ii|| | 1 |
Nearside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Rear parking brake recording little or no effort | 1 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Rear brake binding | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings door shut/sill |6.1.B.2| | 1 |
Nearside Front Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Axle swivel joint has excessive play |2.5.A.3b| | 1 |
Nearside Front Front constant velocity joint is insecure |2.5.C.1b| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Brakes imbalanced across an axle | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Direction indicators not working |1.4.A.2c| | 1 |