Most common failures | No# failures |
---|
Brake pipe excessively corroded | 8 |
Headlamp aim out of alignment | 5 |
Windscreen wiper does not clear the windscreen effectively | 4 |
Rear brake binding | 4 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Offside Rear fog lamp not working |1.3.2b| | 3 |
Brakes imbalanced across an axle | 2 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Front Headlamp aim beam image kick up to the offside |1.8| | 2 |
Nearside Headlamp aim beam image kick up to the offside |1.8| | 2 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 2 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 2 |
Offside Rear Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 2 |
Nearside Headlamp not working on main beam |1.7.5a| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Battery insecure and likely to fall from carrier |4.13 |a| |ii|| | 2 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 2 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Horn not working |1.6.2a| | 1 |
Offside Rear position lamp|s| has less than 50% of the light sources illuminating |1.1.A.3b| | 1 |
Rear fog lamp not working |1.3.2b| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Nearside Front Headlamp aim beam image kick up to the offside |1.8| | 1 |
Nearside Rear fog lamp emits a light other than red |1.3.2e| | 1 |
Nearside Headlamp insecure |1.7.3| | 1 |
Body has a projection caused by corrosion Nearside front wing |6.1.C.1| | 1 |
Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Power steering malfunctioning |2.1.5 |a|| | 1 |
Front Headlamp aim projected beam image is obviously incorrect both kick up to offside (4.1.2 (c)) | 1 |
Drivers seat insecure (6.2.5 (a) (ii)) | 1 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
Rear Exhaust system insecure |6.1.2 |a|| | 1 |
Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Rear Direction indicator adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
Nearside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Rear Hydraulic brake cylinder leaking hydraulic fluid |3.6.A.1| | 1 |
Brake load sensing valve seized |3.6.E.3| | 1 |
Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Front Headlamp aim beam image kick up to the offside |1.6.B1| | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Brake hose twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
Offside Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded inner wheel arch |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded inner wheel arch |2.4.A.3| | 1 |
Front passenger door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Centre Rear Braking system leaking |3.6.A.1| | 1 |
Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) | 1 |
Electrical wiring deteriorated, likely to cause a short |1.9.2b| | 1 |
Offside Front Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Inner Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Brake performance not tested (1.2.1 (g)) | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Rear Mechanical brake component has restricted free movement | 1 |
Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Rear parking brake recording little or no effort | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Horn not a constant note |1.7.1e| | 1 |
Offside Rear fog lamp missing |1.3.2a| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Exhaust system not adequately supported |7.1.1| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Nearside Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Nearside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Headlamp aim beam image kick up to the offside |1.8| | 1 |
rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Offside Front front brakes release unevenly |3.7.B.4| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Outer Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Offside Rear An item not tested |Manual| | 1 |
Rear Brake load sensing valve seized |3.6.E.3| | 1 |
Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Front Direction indicators not working |1.4.A.2c| | 1 |
Rear Direction indicators not working |1.4.A.2c| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Bonnet cannot be secured in the closed position |8.4.1| | 1 |
Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Front brake disc excessively pitted |3.5.1h| | 1 |
Offside Front Headlamp insecure |4.1.1 |c|| | 1 |
Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced |6.1.1 |c| |i|| | 1 |