Most common failures | No# failures |
---|
Brake pipe excessively corroded | 13 |
Registration plate lamp issues | 9 |
Headlamp aim out of alignment | 6 |
Parking brake: efficiency below requirements |3.7.B.7| | 6 |
Offside Rear fog lamp not working |1.3.2b| | 5 |
Service brake: efficiency below requirements |3.7.B.7| | 4 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Registration plate issues | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 3 |
Fuel pipe leaking |7.2.3| | 2 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 2 |
Offside front brake binding |3.7.B.1| | 2 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 2 |
Offside Outer Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 2 |
Offside Side repeater not working |1.4.A.2c| | 2 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 2 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Nearside Front Steering rack gaiter split |2.2.D.2d| | 2 |
Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
Brake load sensing valve linkage seized |3.6.E.3| | 2 |
Brake performance not tested |3.7.A.1| | 2 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Driver`s seat insecure |6.2.A.1| | 1 |
Nearside rear brake grabbing severely |3.7.A.5b| | 1 |
Offside rear brake grabbing severely |3.7.A.5b| | 1 |
Offside Rear Shock absorber has negligible damping effect |2.7.5| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Centre Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Front Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Offside Rear Service brake indicates brake bind |3.7.D.2a| | 1 |
Nearside Front All position lamps not working |1.1.A.3b| | 1 |
Offside Front All position lamps adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Offside Rear All position lamps adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Position lamp switch faulty |1.1.A.1| | 1 |
Nearside Front Front suspension has excessive play in an outer ball joint |2.5.B.2a| | 1 |
Nearside Rear Braking system leaking |3.6.A.1| | 1 |
Offside Front Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Centre Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Parking brake mechanism/associated mounting prescribed area is excessively corroded |3.1.9| | 1 |
Offside Front brake disc excessively pitted |3.5.1h| | 1 |
Nearside Outer Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Windscreen has damage | 1 |
Nearside Rear Rear position lamp|s| insecure |1.1.A.3a| | 1 |
Offside Rear Rear position lamp|s| insecure |1.1.A.3a| | 1 |
Offside Rear Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Hazard warning switch missing |1.4.B.1d| | 1 |
Rear Rear fog lamp not working |1.3.2b| | 1 |
Rear Rear fog lamp switch insecure |1.3.1a| | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Front brake application uneven | 1 |
Windscreen wiper not working (3.4 (a)) | 1 |
Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Rear position lamp|s| insecure |1.1.A.3a| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front Direction indicator not working |1.4.A.2c| | 1 |
Brake hose damaged | 1 |
Offside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Front Bonded suspension unit deteriorated and cannot function as intended |2.4.F.3| | 1 |
Emissions not tested |7.0| | 1 |
Brake pump/compressor drive belt excessively deteriorated |3.6.F.1| | 1 |
Offside Rear Brake pipe leaking |3.6.A.1| | 1 |
Offside Front Direction indicator incomplete |1.5.A1b| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Front Headlamp not working on main beam |1.7.5a| | 1 |
Offside Obligatory mirror missing |8.1.1| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Front Side repeater not working |1.4.A.2c| | 1 |
Offside Rear wheel cylinder leaking |3.6.A.1| | 1 |
Driver`s seat insecure |6.2.A.1| | 1 |
Front passenger seat insecure |6.2.3| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Rear Fuel cap/sealing device does not fasten securely by positive means |7.2.4b| | 1 |
Nearside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Windscreen wiper blade insecure | 1 |
Brake pedal has no servo assistance |3.3.B.2| | 1 |