MOT History from tests of petrol OPEL VECTRAs year 1991

Review the list of common OPEL VECTRA failures below or to perform a specific mot history check on your OPEL then use our popular KnowYourCar service

mot history

Pass percent:56.67%

(The average a petrol OPEL VECTRA year 1991 passes without issue)

Based on:30 MOT Tests

Most common failures	No# failures
Registration plate lamp issues	5
Offside Rear wheel bearing has excessive play \|2.6.2\|	2
Nearside Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	2
Nearside Front Direction indicator not working \|1.4.A.2c\|	2
Offside Rear Rear wheel bearing rough when rotated \|2.6.1\|	2
Offside Rear Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	2
Centre Exhaust has a major leak of exhaust gases \|7.1.2\|	1
Nearside Windscreen wiper blade deteriorated \|8.2.2\|	1
Offside Windscreen wiper blade deteriorated \|8.2.2\|	1
Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings \|6.1.B.2\|	1
Fuel system component insecure \|7.2.1\|	1
Offside Rear wheel bearing rough when rotated \|2.6.1\|	1
Offside Side repeater incorrect colour \|1.4.A.2f\|	1
Stop lamp not working \|1.2.1b\|	1
Nearside Outer Seat belt anchorage prescribed area is excessively corroded \|5.2.6\|	1
Offside Lower Seat belt anchorage prescribed area is excessively corroded \|5.2.6\|	1
Offside Rear Suspension spring mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Front Anti-roll bar linkage cracked \|2.4.G.1\|	1
Rear wheel bearing has excessive play \|2.6.2\|	1
Offside Headlamp aim beam image kick up to the offside \|1.8\|	1
Nearside Headlamp aim not tested \|1.8.A.1c\|	1
Side repeater missing \|1.4.A.2b\|	1
Offside Rear fog lamp missing \|1.3.2a\|	1
Nearside Headlamp not working on dipped beam \|1.7.5a\|	1
Windscreen wiper blade insecure	1
Rear fog lamp not working \|1.3.2b\|	1
Nearside Rear Body has a sharp edge caused by corrosion \|6.1.C.1\|	1
Offside Rear Body has a sharp edge caused by corrosion \|6.1.C.1\|	1
Nearside Headlamp aim aimed so that it dazzles other road users \|1.8.A.1a\|	1
Offside Headlamp aim aimed so that it dazzles other road users \|1.8.A.1a\|	1
Hazard warning lamps not flashing in phase, with ignition on \|1.4.B.1f\|	1
Hazard warning lamps not flashing in phase, with ignition off \|1.4.B.1f\|	1
Anti-lock braking system warning lamp indicates an ABS fault	1
Offside Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Front Anti-roll bar linkage fractured \|2.4.G.1\|	1
Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement \|2.4.G.2\|	1
Offside Rear Rear fog lamp not working \|1.3.2b\|	1
Nearside Rear Rear wheel bearing rough when rotated \|2.6.1\|	1
Nearside Rear wheel bearing has excessive play \|2.6.2\|	1
Nearside Side repeater missing \|1.4.A.2b\|	1
Offside Side repeater missing \|1.4.A.2b\|	1
Offside Stop lamp not working \|1.2.1b\|	1
Rear Rear fog lamp not working \|1.3.2b\|	1
Parking brake lever, pawl mechanism pivots or their associated mountings are insecure \|3.1.4b\|	1
Hazard warning switch faulty \|1.4.B.1d\|	1
Parking brake: efficiency below requirements \|3.7.B.7\|	1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Most common failures	No# failures
Registration plate lamp issues	5
Offside Rear wheel bearing has excessive play \|2.6.2\|	2
Nearside Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	2
Nearside Front Direction indicator not working \|1.4.A.2c\|	2
Offside Rear Rear wheel bearing rough when rotated \|2.6.1\|	2
Offside Rear Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	2
Centre Exhaust has a major leak of exhaust gases \|7.1.2\|	1
Nearside Windscreen wiper blade deteriorated \|8.2.2\|	1
Offside Windscreen wiper blade deteriorated \|8.2.2\|	1
Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings \|6.1.B.2\|	1
Fuel system component insecure \|7.2.1\|	1
Offside Rear wheel bearing rough when rotated \|2.6.1\|	1
Offside Side repeater incorrect colour \|1.4.A.2f\|	1
Stop lamp not working \|1.2.1b\|	1
Nearside Outer Seat belt anchorage prescribed area is excessively corroded \|5.2.6\|	1
Offside Lower Seat belt anchorage prescribed area is excessively corroded \|5.2.6\|	1
Offside Rear Suspension spring mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Front Anti-roll bar linkage cracked \|2.4.G.1\|	1
Rear wheel bearing has excessive play \|2.6.2\|	1
Offside Headlamp aim beam image kick up to the offside \|1.8\|	1
Nearside Headlamp aim not tested \|1.8.A.1c\|	1
Side repeater missing \|1.4.A.2b\|	1
Offside Rear fog lamp missing \|1.3.2a\|	1
Nearside Headlamp not working on dipped beam \|1.7.5a\|	1
Windscreen wiper blade insecure	1
Rear fog lamp not working \|1.3.2b\|	1
Nearside Rear Body has a sharp edge caused by corrosion \|6.1.C.1\|	1
Offside Rear Body has a sharp edge caused by corrosion \|6.1.C.1\|	1
Nearside Headlamp aim aimed so that it dazzles other road users \|1.8.A.1a\|	1
Offside Headlamp aim aimed so that it dazzles other road users \|1.8.A.1a\|	1
Hazard warning lamps not flashing in phase, with ignition on \|1.4.B.1f\|	1
Hazard warning lamps not flashing in phase, with ignition off \|1.4.B.1f\|	1
Anti-lock braking system warning lamp indicates an ABS fault	1
Offside Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Front Anti-roll bar linkage fractured \|2.4.G.1\|	1
Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement \|2.4.G.2\|	1
Offside Rear Rear fog lamp not working \|1.3.2b\|	1
Nearside Rear Rear wheel bearing rough when rotated \|2.6.1\|	1
Nearside Rear wheel bearing has excessive play \|2.6.2\|	1
Nearside Side repeater missing \|1.4.A.2b\|	1
Offside Side repeater missing \|1.4.A.2b\|	1
Offside Stop lamp not working \|1.2.1b\|	1
Rear Rear fog lamp not working \|1.3.2b\|	1
Parking brake lever, pawl mechanism pivots or their associated mountings are insecure \|3.1.4b\|	1
Hazard warning switch faulty \|1.4.B.1d\|	1
Parking brake: efficiency below requirements \|3.7.B.7\|	1

MOT History from tests of petrol OPEL VECTRAs year 1991

Find us on Facebook