Most common failures | No# failures |
---|
Brakes imbalanced across an axle | 5 |
Rear brake binding | 4 |
Brake pipe excessively corroded | 4 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
Nearside Rear Direction indicator incomplete |1.5.A1b| | 2 |
Registration plate issues | 2 |
Brake pedal spongy |3.3.B.1b| | 1 |
Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering anti roll bar detached away from chassis |6.1.1 |c| |ii|| | 1 |
Offside Front Vehicle structure is deformed and structural rigidity is significantly reduced under drivers floor |6.1.1 |a| |i|| | 1 |
Nearside Rear Vehicle structure is fractured and structural rigidity is significantly reduced |6.1.1 |a| |i|| | 1 |
Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced in side wheel arch |6.1.1 |c| |i|| | 1 |
Offside Rear Integral body structure is fractured and structural rigidity is significantly reduced in side wheel arch |6.1.1 |a| |i|| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Lower Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.1 |c| |ii|| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake pedal creeps down under servo assistance and touches the floor |3.3.C.3| | 1 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Rear Lower Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake performance not tested |3.7.A.1| | 1 |
Rear Fuel pipe leaking |7.2.3| | 1 |
Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 1 |
Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Service brake: efficiency below requirements |3.7.C.1a| | 1 |
Nearside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Rear fog lamp tell tale not working |1.3.1b| | 1 |
Registration plate lamp issues | 1 |
Nearside Rear Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |