Most common failures | No# failures |
---|
Headlamp aim out of alignment | 7 |
Windscreen wiper does not clear the windscreen effectively | 5 |
Registration plate issues | 3 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Horn not working |1.6.2a| | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 2 |
Offside Headlamp not working on dipped beam |1.7.5a| | 2 |
Offside Front constant velocity joint gaiter split |2.5.C.1a| | 2 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 2 |
Registration plate lamp issues | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Rear Suspension component mounting prescribed area is excessively corroded Both sides |2.4.A.3| | 1 |
Brake hose inappropriately repaired Both front |3.6.A.3| | 1 |
Nearside Front Macpherson strut inappropriately repaired |2.4.A.2| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Headlamp aim not tested |1.8.A.1c| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Nearside Rear Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Rear Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Windscreen washer not working | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis (5.3.6 (a) (i)) | 1 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 1 |
Rear brake disc in such a condition that it is seriously weakened | 1 |
Rear parking brake recording little or no effort | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Offside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Exhaust emissions likely to be affected by an exhaust leak flexi (8.2.1.1 (b)) | 1 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i)) | 1 |
Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Brakes imbalanced across an axle | 1 |
Brake fluid significantly below minimum mark (1.1.10 (d) (ii)) | 1 |
Main beam `tell-tale` not working |1.7.4c| | 1 |
Windscreen wiper blade insecure | 1 |
Offside Rear fog lamp emits a light other than red |1.3.2e| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Front constant velocity joint is insecure |2.5.C.1b| | 1 |
Offside Outer Rear Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill (6.2.2 (d) (i)) | 1 |
Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Engine mounting (6.2.2 (d) (i)) | 1 |
Brake performance not tested (1.2.1 (g)) | 1 |
Emissions not tested (8.2.1.2 (d)) | 1 |
Nearside Front Direction indicator insecure |1.4.A.2b| | 1 |
Offside Front Direction indicator insecure |1.4.A.2b| | 1 |
Offside Front Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Nearside Outer Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Outer Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Inner Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Inner Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake pipe excessively corroded | 1 |
Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |
Anti-lock braking system warning lamp indicates an ABS fault | 1 |
Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Nearside Front coil spring fractured |2.4.C.1a| | 1 |
Offside Front Seat belt has a cut which has significantly weakened the webbing |5.2.2a| | 1 |
Offside Rear Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Nearside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Stop lamp not working All |1.2.1b| | 1 |