Most common failures | No# failures |
---|
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 4 |
Rear fog lamp not working (4.5.1 (a) (ii)) | 3 |
Registration plate lamp issues | 3 |
Headlamp aim out of alignment | 3 |
Registration plate issues | 2 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 2 |
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 2 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 2 |
Windscreen washer not working | 2 |
Horn not working (7.7 (a)) | 1 |
Offside Rear Inner Position lamp not working (4.2.1 (a) (ii)) | 1 |
Power steering fluid reservoir empty (2.1.5 (b) (ii)) | 1 |
Anti-lock braking system warning lamp indicates an ABS fault | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
Nearside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Service brake: efficiency below requirements |3.7.C.1a| | 1 |
Nearside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Offside Upper Suspension arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Emissions oxygen sensor missing where one was fitted as standard (8.2.1.1 (a)) | 1 |
Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Emissions not tested aborted no lambda reading (8.2.1.2 (d)) | 1 |
Nearside Front Lower Suspension arm pin or bush likely to become detached (5.3.4 (a) (ii)) | 1 |
Brake valve leaking Leaking from back of abs pump. (1.1.7 (d) (i)) | 1 |
Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a)) | 1 |
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |
Nearside Rear Inner Drive shaft securing bolt loose (6.1.7 (a) (i)) | 1 |
Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Nearside Front Side repeater not working (4.4.1 (a) (ii)) | 1 |
Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split (6.1.7 (g) (ii)) | 1 |
Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Nearside Front Shock absorbers has a serious fluid leak | 1 |
Nearside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
Offside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
Nearside Headlamp lens seriously defective (4.1.1 (b) (ii)) | 1 |
Offside Headlamp lens seriously defective (4.1.1 (b) (ii)) | 1 |