Most common failures | No# failures |
---|
Windscreen washer not working | 3 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
Headlamp aim out of alignment | 2 |
Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a)) | 1 |
Registration plate issues | 1 |
Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
Exhaust carbon monoxide content at idle exceeds manufacturers specified limits (8.2.1.2 (b)) | 1 |
Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
Brake performance not tested (1.2.1 (g)) | 1 |
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 1 |
Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Front Sub-frame corroded and seriously weakened Towards rear of subframe o/s (5.3.3 (b) (i)) | 1 |
Offside Seat belt anchorage prescribed area strength or continuity significantly reduced sill/floor (7.1.1 (a) (i)) | 1 |
Nearside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i)) | 1 |
Nearside Rear Brake disc contaminated covered in brake fluid (1.1.14 (b)) | 1 |
Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength behind both front wheels (5.3.6 (a) (i)) | 1 |
Horn not working (7.7 (a)) | 1 |
Steering wheel has movement relative to the column indicating looseness (2.2.1 (a) (i)) | 1 |
Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c)) | 1 |
Emissions not tested (8.2.1.2 (d)) | 1 |
Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a)) | 1 |
Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i)) | 1 |
Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i)) | 1 |
Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i)) | 1 |
Supplementary Restraint System warning lamp indicates a fault |5.4.2| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Headlamp aim not tested |1.8.A.1c| | 1 |
Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Rear fog lamp switch missing (4.5.3 (a) (ii)) | 1 |
Rear fog lamp tell-tale missing (4.9.1 (a) (ii)) | 1 |
Rear fog lamp missing |4.5.1 |a| |ii|| | 1 |