| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 7 |
| Registration plate lamp issues | 5 |
| Parking brake: efficiency below requirements |3.7.B.7| | 4 |
| Offside Steering rack gaiter split |2.2.D.2d| | 4 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 3 |
| Battery insecure |1.9.1| | 3 |
| Parking brake lever has no reserve travel |3.1.6b| | 3 |
| Brake pipe excessively corroded | 3 |
| Nearside Front Steering rack gaiter split |2.2.D.2d| | 2 |
| Rear fog lamp not working |1.3.2b| | 2 |
| Registration plate issues | 2 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
| Headlamp aim out of alignment | 2 |
| Windscreen washer not working | 2 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Electrical wiring inadequately supported |1.9.2a| | 1 |
| Offside Rear fog lamp missing |1.3.2a| | 1 |
| Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Parking brake lever has excessive movement indicating incorrect adjustment |1.1.6 |c|| | 1 |
| Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
| Speedometer clearly inoperative |6.7.2| | 1 |
| Offside Rear Inner Suspension component mounting prescribed area is excessively corroded sill holed |2.4.A.3| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded INNER/OUTER BODY SILL |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is inadequately repaired FLOOR TO SILL AREA |2.4.A.3| | 1 |
| Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement D BUSH WORN |2.4.G.2| | 1 |
| Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement D BUSH |2.4.G.2| | 1 |
| Offside Front Steering locking device missing |2.2.C.1g| | 1 |
| Centre Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
| Offside Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
| Nearside Steering rack gaiter split |2.2.D.2d| | 1 |
| Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
| Nearside Inner Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Inner Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Rear fog lamp tell tale not working |1.3.1b| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Body component damaged and likely to cause injury bracket sticking out |6.2.1 |a| |i|| | 1 |
| Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt |2.1.3 |g| |ii|| | 1 |
| Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Rear parking brake recording little or no effort | 1 |
| Fuel cap/sealing device missing |7.2.4a| | 1 |
| Rear fog lamp missing |1.3.2a| | 1 |
| Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Offside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Offside Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b)) | 1 |
| Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill panel (7.1.1 (a) (i)) | 1 |
| Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill panel (5.3.6 (a) (i)) | 1 |
| Offside Front Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Outer Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting SILL HOLED FULL LENGTH (6.2.2 (d) (i)) | 1 |
| Offside Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting SILL HOLED IN 2 PLACES (6.2.2 (d) (i)) | 1 |
| Offside Rear Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting CORNER VALANCE HOLED (6.2.2 (d) (i)) | 1 |
| Nearside Rear Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting CORNER VALANCE HOLED (6.2.2 (d) (i)) | 1 |
| Rear Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting CROSSMEMBER HOLED IN MULTIPLE PLACES (6.2.2 (d) (i)) | 1 |