Most common failures | No# failures |
---|
Brake pipe excessively corroded | 7 |
Windscreen wiper does not clear the windscreen effectively | 6 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 5 |
Rear brake binding | 3 |
Offside Side repeater incorrect colour |1.4.A.2f| | 3 |
Rear parking brake recording little or no effort | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Headlamp aim out of alignment | 3 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Fuel cap/sealing device sealing washer deteriorated |7.2.4c| | 2 |
Nearside Rear Upper Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Wheel arch (6.1.1 (c) (i)) | 2 |
Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 2 |
Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 2 |
Brake hose excessively deteriorated | 2 |
Nearside Stop lamp not working |1.2.1b| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Front Anti-roll bar linkage modified and seriously weakened |2.4.A.2| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Nearside Rear Seat belt retracting mechanism defective (7.1.2 (e)) | 1 |
Offside Rear Seat belt retracting mechanism defective (7.1.2 (e)) | 1 |
Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Nearside Rear Suspension unit leaking (5.3.5 (c)) | 1 |
Nearside Front Fluid suspension unit leaking |2.4.D.2| | 1 |
Offside Front Fluid suspension unit leaking |2.4.D.2| | 1 |
Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
Stop lamp not working |1.2.1b| | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Fuel cap/sealing device sealing washer missing |7.2.4c| | 1 |
Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Inner Rear Lower Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Offside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Emissions not tested |8.2.1.2 |d|| | 1 |
Exhaust emissions likely to be affected by an exhaust leak Manifold |8.2.1.1 |b|| | 1 |
Windscreen washer not working | 1 |
Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Brakes imbalanced across an axle | 1 |
Offside Rear Upper Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Wheel arch (6.1.1 (c) (i)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Offside Rear Lower Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) | 1 |
Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) | 1 |
Nearside Front Steering linkage modified such that the steering is adversely affected DRAG LINK ARM BUSHES (2.1.3 (f) (ii)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |
Nearside Front Braking system leaking |3.6.A.1| | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Nearside Front Brake hose twisted |3.6.B.4c| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Rear brake application uneven | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Horn not working |1.6.2a| | 1 |
Offside Rear Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear position lamp|s| excessively damaged so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Stop lamp excessively damaged so that it is not visible from a reasonable distance |1.2.1d| | 1 |
Offside rear brakes release unevenly |3.7.B.4| | 1 |
Offside Rear Upper Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Upper Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |