| Most common failures | No# failures |
|---|
| Registration plate issues | 33 |
| Headlamp aim out of alignment | 27 |
| Windscreen wiper does not clear the windscreen effectively | 19 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 8 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 7 |
| Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 6 |
| Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 6 |
| Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 6 |
| Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h)) | 4 |
| Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a)) | 3 |
| Nearside Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a)) | 3 |
| Offside Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a)) | 3 |
| Brake pipe excessively corroded | 3 |
| Exhaust catalytic converter missing where one was fitted as standard |7.1.3| | 3 |
| Electronic stability control warning lamp indicates a fault (7.12 (e)) | 3 |
| Anti-lock braking system warning lamp indicates an ABS fault | 3 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 3 |
| Front brake disc in such a condition that it is seriously weakened | 3 |
| Windscreen has damage | 2 |
| Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 2 |
| Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 2 |
| Emissions unable to be completed (8.2.1.2 (d)) | 2 |
| Nearside Front Shock absorbers has a serious fluid leak | 2 |
| Windscreen washer not working | 2 |
| Offside Rear Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 2 |
| Exhaust catalytic converter missing where one was fitted as standard BOTH (8.2.1.1 (a)) | 1 |
| Emissions not tested CO to high at .65 LAMBDA to high at 1.067 full emissions test not completed as catalysts removed. (8.2.1.2 (d)) | 1 |
| Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition |7.1.4| | 1 |
| Front Service brake juddering severely |3.7.C.2| | 1 |
| Exhaust catalytic converter missing where one was fitted as standard Both (8.2.1.1 (a)) | 1 |
| Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
| Headlamp cleaning device for LED or HID headlamp inoperative both |4.1.6 |a| |ii|| | 1 |
| Exhaust emissions exceed manufacturers specified limit (8.2.2.2 (a)) | 1 |
| Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting jacking point (6.2.2 (d) (i)) | 1 |
| Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting jacking point (6.2.2 (d) (i)) | 1 |
| Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arches excessively corroded & holes present. (5.3.6 (a) (i)) | 1 |
| Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced inner arches excessively corroded & holes present. (7.1.1 (a) (i)) | 1 |
| Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced inner arches excessively corroded & holes present. (7.1.1 (a) (i)) | 1 |
| Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill excessively corroded & holes present. (5.3.6 (a) (i)) | 1 |
| Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Nearside Front position lamp|s| not working side light / daylight running lamp not working |1.1.A.3b| | 1 |
| Front Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Emissions not tested due to exhaust leak (8.2.1.2 (d)) | 1 |
| Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arches excessively corroded & holes present. (5.3.6 (a) (i)) | 1 |
| Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
| Nearside Front Outer Drive shaft joint excessively worn (6.1.7 (c) (i)) | 1 |
| Offside Front Outer Drive shaft joint excessively worn (6.1.7 (c) (i)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Nearside Front Headlamp has a product on the lens so that the light output is severely reduced No beam pattern (4.1.4 (b)) | 1 |
| Offside Front Headlamp has a product on the lens so that the light output is severely reduced N o beam pattern (4.1.4 (b)) | 1 |
| Nearside Front Lower Suspension arm locating pin locking device missing |2.4.G.3b| | 1 |
| Offside Front Lower Suspension arm locating pin retaining device missing |2.4.G.3b| | 1 |
| Emissions not tested Engine overheated (8.2.1.2 (d)) | 1 |
| Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
| Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Rear Anti-roll bar linkage ball joint excessively worn |5.3.4 |a| |i|| | 1 |
| Front Exhaust has a major leak of exhaust gases flexi (6.1.2 (a)) | 1 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds default limits |8.2.1.2 |b|| | 1 |
| Exhaust carbon monoxide content at idle exceeds default limits |8.2.1.2 |b|| | 1 |
| Exhaust catalytic converter missing where one was fitted as standard |8.2.1.1 |a|| | 1 |
| Nearside Headlamp cleaning device inoperative |1.7.2| | 1 |
| Offside Headlamp cleaning device inoperative |1.7.2| | 1 |
| Headlamp not working on dipped beam both (4.1.1 (a) (ii)) | 1 |
| Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
| Nearside Rear Anti-roll bar has excessive play in a ball joint |2.4.G.2| | 1 |
| Emissions unable to be completed c/o reading to high (8.2.1.2 (d)) | 1 |
| Rear brake disc in such a condition that it is seriously weakened | 1 |
| Nearside Exhaust catalytic converter missing where one was fitted as standard |7.1.3| | 1 |
| Offside Exhaust catalytic converter missing where one was fitted as standard |7.1.3| | 1 |
| Offside Rear Anti-roll bar has excessive play in a ball joint |2.4.G.2| | 1 |
| Windscreen damaged and affecting the driver`s view of the road |3.2 |a| |ii|| | 1 |
| Exhaust carbon monoxide content at idle exceeds manufacturers specified limits (8.2.1.2 (b)) | 1 |
| Nearside Front Headlamp cleaning device inoperative |1.7.2| | 1 |
| Offside Front Headlamp cleaning device inoperative |1.7.2| | 1 |
| Registration plate lamp issues | 1 |
| Drivers door catch missing (6.2.3 (c) (ii)) | 1 |
| Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i)) | 1 |
| Emissions not tested Large hole front flexi (centre pipe) (8.2.1.2 (d)) | 1 |
| Nearside Side repeater light intensity significantly reduced |4.4.3 |a|| | 1 |
| Offside Side repeater light intensity significantly reduced |4.4.3 |a|| | 1 |
| Rear fog lamp missing |1.3.2a| | 1 |
| Nearside Rear Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
| Offside Rear Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |