| Most common failures | No# failures |
|---|
| Brake pipe excessively corroded | 6 |
| Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3) | 3 |
| Exhaust has a major leak of exhaust gases (7.1.2) | 3 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Nearside Front Service brake excessively binding (1.2.1 (f)) | 2 |
| Headlamp aim out of alignment | 2 |
| Nearside Front constant velocity joint gaiter split (2.5.C.1a) | 2 |
| Registration plate lamp issues | 2 |
| Brake hose excessively deteriorated | 2 |
| Offside Headlamp not working on dipped beam (1.7.5a) | 1 |
| Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i)) | 1 |
| Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Nearside front brake binding (3.7.B.1) | 1 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3) | 1 |
| Nearside Front Inner Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4) | 1 |
| Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill holed in various places (6.1.1 (c) (i)) | 1 |
| Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill end holed (6.1.1 (c) (i)) | 1 |
| Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
| Front Position lamp not working both (4.2.1 (a)) | 1 |
| Rear Position lamp not working both (4.2.1 (a)) | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3) | 1 |
| Nearside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2) | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3) | 1 |
| Brakes imbalanced across an axle | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3) | 1 |
| Offside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2) | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3) | 1 |
| Offside front brake binding (3.7.B.1) | 1 |
| front brake binding (3.7.B.1) | 1 |
| Rear Exhaust has a major leak of exhaust gases snapped completely (6.1.2 (a)) | 1 |
| Rear Exhaust has part of the system excessively deteriorated (7.1.1a) | 1 |
| Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
| Nearside Seat belt not functioning as intended Webbing twisted. (7.1.2 (c)) | 1 |
| Offside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Rear Shock absorber has negligible damping effect (2.7.5) | 1 |
| Offside Rear Shock absorber has negligible damping effect (2.7.5) | 1 |
| Offside Rear Shock absorber has a serious fluid leak (2.7.3) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor near front subframe rear mount (5.3.6 (a) (i)) | 1 |
| Offside Front constant velocity joint gaiter split (2.5.C.1a) | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Battery insecure (1.9.1) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6) | 1 |
| Registration plate issues | 1 |
| Offside Rear fog lamp not working (1.3.2b) | 1 |
| Offside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a) | 1 |
| Offside Front position lamp(s) incorrect colour (1.1.A.3e) | 1 |
| Nearside Front position lamp(s) incorrect colour (1.1.A.3e) | 1 |
| Offside Headlamp not in good working order adversely affecting beam image (1.2.4a) | 1 |
| Offside Front Front constant velocity joint gaiter split (2.5.C.1a) | 1 |
| Nearside Windscreen wiper blade deteriorated (8.2.2) | 1 |