Most common failures | No# failures |
---|
Registration plate lamp issues | 4 |
Headlamp aim out of alignment | 2 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Brakes imbalanced across an axle | 2 |
Stop lamp remains on when the brakes are released | 2 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Brake pipe inadequately clipped |3.6.B.1| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Indicator tell tale inoperative |1.4.A.2a| | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Fuel cap/sealing device sealing washer missing |7.2.4c| | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Offside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
Nearside Front Upper Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Front Lower Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Front Direction indicator not working |1.4.A.2c| | 1 |
Nearside Front Tie bar/rod has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Rear brake application uneven | 1 |
Rear brake binding | 1 |
Nearside Rear Rear reflector missing |1.5.1a| | 1 |
Offside Indicator switch faulty |1.4.A.1| | 1 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Offside Front Brake actuating linkage mounting prescribed area is excessively corroded |3.3.A.2| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Brake pipe excessively corroded | 1 |
Nearside Rear Brake pipe inadequately supported |3.6.B.1| | 1 |