Most common failures | No# failures |
---|
Brake pipe excessively corroded | 6 |
Headlamp aim out of alignment | 5 |
Windscreen wiper does not clear the windscreen effectively | 5 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Registration plate lamp issues | 3 |
Nearside Front Track rod end ball joint has excessive play |2.2.B.1f| | 2 |
Nearside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
Offside Steering rack gaiter split |2.2.D.2d| | 2 |
Nearside Rear Shock absorber casing damaged externally so the unit does not function |2.7.2a| | 1 |
Offside Rear Shock absorber has negligible damping effect |2.7.5| | 1 |
Offside Outer Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Nearside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
Front Exhaust system not adequately supported |7.1.1| | 1 |
Offside Rear position lamp|s| incomplete |1.1.4a| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Brakes imbalanced across an axle | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Inner Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Offside Outer Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Offside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Offside Brake pipe leaking |3.6.A.1| | 1 |
Offside Rear Brake load sensing valve linkage defective and function impaired |3.6.E.3| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Rear Shock absorber has negligible damping effect |2.7.5| | 1 |
Offside Outer Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Tie bar/rod attachment bracket/mounting bolt missing |2.4.G.1| | 1 |
Offside Tie bar/rod attachment bracket/mounting bolt missing |2.4.G.1| | 1 |
Fuel cap/sealing device sealing washer torn |7.2.4c| | 1 |
Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Rear Spare wheel carrier insecure |6.4.2| | 1 |
Nearside Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Offside Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Horn not working |1.6.2a| | 1 |
Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Inner Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |