| Most common failures | No# failures |
|---|
| Registration plate lamp issues | 10 |
| Windscreen wiper does not clear the windscreen effectively | 10 |
| Headlamp aim out of alignment | 9 |
| Brake pipe excessively corroded | 7 |
| Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 4 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 4 |
| Offside Rear Direction indicator incorrect colour |1.4.A.2f| | 3 |
| Nearside Rear Direction indicator incorrect colour |1.4.A.2f| | 2 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Parking brake: efficiency below requirements |3.7.B.7| | 2 |
| Offside Front Direction indicator incorrect colour |1.4.A.2f| | 2 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 2 |
| Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 2 |
| Brakes imbalanced across an axle | 2 |
| Supplementary Restraint System warning lamp indicates a fault |5.4.2| | 2 |
| Front brake disc in such a condition that it is seriously weakened | 2 |
| Nearside Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 2 |
| Nearside Stop lamp not working |1.2.1b| | 2 |
| Rear fog lamp not working |1.3.2b| | 2 |
| Brake hose excessively deteriorated | 2 |
| Registration plate issues | 2 |
| Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 2 |
| Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
| Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
| Nearside Side repeater not working |1.4.A.2c| | 1 |
| Offside Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Nearside Side repeater incorrect colour |1.4.A.2f| | 1 |
| Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 1 |
| Nearside Rear coil spring fractured |2.4.C.1a| | 1 |
| Offside Rear coil spring fractured |2.4.C.1a| | 1 |
| Nearside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Offside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Offside Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Nearside Rear Direction indicators incorrect colour |1.4.A.2f| | 1 |
| Offside Rear Direction indicators incorrect colour |1.4.A.2f| | 1 |
| Nearside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
| Offside Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a| | 1 |
| Offside Front Lower Ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Nearside Front Lower Ball joint has excessive play |2.2.B.1f| | 1 |
| Rear brake application uneven | 1 |
| Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 1 |
| Nearside Front Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
| Offside Front Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
| Centre Rear Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Front Exhaust system not adequately supported |7.1.1| | 1 |
| Brake performance not tested |3.7.A.1| | 1 |
| Rear fog lamp tell tale not working |1.3.1b| | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner outer sill (5.3.6 (a) (i)) | 1 |
| Nearside Front Anti-roll bar linkage insecurely attached Link pin (5.3.3 (a) (i)) | 1 |
| Rear Mechanical brake component has restricted free movement | 1 |
| Direction indicator incorrect colour |1.4.A.2f| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Offside Rear Rear reflector more than 50% obscured |1.5.1b| | 1 |
| Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
| Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Rear Upper Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Rear Upper Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Horn not working (7.7 (a)) | 1 |
| Offside Front Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting l/h/d vehicle (6.2.2 (d) (i)) | 1 |
| Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting l/h/d vehicle (6.2.2 (d) (i)) | 1 |
| Central Front Prop shaft bearing housing likely to fail (6.1.7 (f) (ii)) | 1 |
| Front Headlamp aim projected beam image is obviously incorrect both headlights (4.1.2 (c)) | 1 |
| Offside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Offside Side repeater not working (4.4.1 (a) (ii)) | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
| Rear fog lamp obviously incorrectly positioned |4.5.4 |a|| | 1 |
| Rear Direction indicator incorrect colour both |4.4.3 |a|| | 1 |
| Offside Front Headlamps matched pair are not the same colour |1.7.6| | 1 |
| Centre Drive shaft which forms part of the suspension support bearing excessively worn |2.4.G.4d| | 1 |
| Offside Rear Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Nearside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Exhaust engine idle speed too high |7.3.D.1| | 1 |
| Nearside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Rear fog lamp switch faulty |1.3.1a| | 1 |
| Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 1 |
| Front Macpherson strut worn and seriously weakened |2.4.G.1| | 1 |