Most common failures | No# failures |
---|
Registration plate lamp issues | 11 |
Brake pipe excessively corroded | 10 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 9 |
Headlamp aim out of alignment | 9 |
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 5 |
Windscreen wiper does not clear the windscreen effectively | 4 |
Nearside Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 4 |
Windscreen wiper blade insecure | 3 |
Parking brake lever has no reserve travel |3.1.6b| | 2 |
Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 2 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 2 |
Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
Rear Rear fog lamp switch faulty |1.3.1a| | 1 |
Offside Inner Front Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 1 |
Offside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Rear Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 1 |
Rear Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
Rear Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 1 |
Nearside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Nearside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Rear fog lamp switch faulty |1.3.1a| | 1 |
Offside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Inner Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Offside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Front Front suspension has excessive movement at a suspension ball joint |2.5.A.1c| | 1 |
Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Front Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Offside Front Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Nearside Front Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Registration plate issues | 1 |
Front brake disc in such a condition that it is seriously weakened | 1 |
Rear brake binding | 1 |
Front brake excessively fluctuating | 1 |
Nearside Rear Road wheel fixings not compatible |4.2.B.2| | 1 |
Nearside Front coil spring incomplete |2.4.C.1a| | 1 |
Rear Mechanical brake component has restricted free movement | 1 |
Nearside Front Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Rear fog lamp tell tale not working |1.3.1b| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Exhaust emits an excessive level of metered smoke for a turbo charged engine |7.4.B.3b| | 1 |
Offside Front Anti-roll bar has excessive play in a pin/bearing |2.4.G.2| | 1 |
Front Exhaust system not adequately supported |7.1.1| | 1 |
Offside Front Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Nearside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Nearside Front Headlamp has a product on the lens so that the light output is severely reduced |1.7.5a| | 1 |
Offside Front Headlamp has a product on the lens so that the light output is severely reduced |1.7.5a| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Offside Outer Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Front Bonded suspension unit deteriorated and cannot function as intended |2.4.F.3| | 1 |
Offside Front Bonded suspension unit deteriorated and cannot function as intended |2.4.F.3| | 1 |