Most common failures | No# failures |
---|
Parking brake: efficiency below requirements |3.7.B.7| | 5 |
Registration plate lamp issues | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Headlamp aim out of alignment | 3 |
Rear brake binding | 3 |
Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 2 |
Offside Front wheel bearing has excessive play |2.5.A.3c| | 2 |
Offside Rear Shock absorber insecure |2.7.2b| | 1 |
Nearside Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill and wheel arch area near leaf spring mount |2.4.A.3| | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Steering wheel in a condition that hampers proper control |2.1.1| | 1 |
Brake pedal spongy |3.3.B.1b| | 1 |
Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Horn not working |1.6.2a| | 1 |
Nearside Front Side repeater incomplete |1.5.A1b| | 1 |
Nearside Rear Brake lever has restricted free movement |3.5.1k| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Brakes imbalanced across an axle | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Steering column shaft locking device insecure |2.1.6| | 1 |
Nearside Rear Leaf spring has excessive wear in an anchor pin and/or bush |2.4.B.2| | 1 |
Suspension component mounting prescribed area is excessively corroded behind rear bumper/inner body panel within 30cm of o/s/r leaf spring rear mount |2.4.A.3| | 1 |
Offside Rear Leaf spring fractured |2.4.B.1a| | 1 |
Nearside Rear Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Nearside Rear Leaf spring deteriorated and seriously weakened |2.4.B.1a| | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Rear Braking system leaking |3.6.A.1| | 1 |
Nearside Rear wheel cylinder leaking |3.6.A.1| | 1 |
Offside Rear Direction indicator not working |1.4.A.2c| | 1 |
Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Rear Shock absorber has negligible damping effect |2.7.5| | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i)) | 1 |
Nearside Front Shock absorbers has a serious fluid leak | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Suspension component mounting prescribed area is excessively corroded rear inner sill |2.4.A.3| | 1 |
Stop lamp not working |1.2.1b| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Offside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Offside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |