| Most common failures | No# failures |
|---|
| Parking brake: efficiency below requirements |3.7.B.7| | 8 |
| Service brake: efficiency below requirements |3.7.B.7| | 8 |
| Brakes imbalanced across an axle | 7 |
| Windscreen wiper does not clear the windscreen effectively | 7 |
| Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 6 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 6 |
| Rear parking brake recording little or no effort | 6 |
| Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 6 |
| Headlamp aim out of alignment | 5 |
| Exhaust system not adequately supported |7.1.1| | 4 |
| Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 4 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 4 |
| Brake hose excessively deteriorated | 4 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 3 |
| Registration plate issues | 3 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 3 |
| Registration plate lamp issues | 3 |
| Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Headlamp not working on main beam |1.7.5a| | 2 |
| Brake pipe excessively corroded | 2 |
| Nearside Stop lamp not working |1.2.1b| | 2 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 2 |
| Fuel system component leaking |7.2.3| | 2 |
| Windscreen wiper blade insecure | 2 |
| Nearside Front wheel bearing rough when rotated |2.5.A.2| | 2 |
| Offside front brake binding |3.7.B.1| | 2 |
| Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Towbar component fractured |6.6.1| | 1 |
| Towbar support obviously of an inappropriate type |6.6.2| | 1 |
| Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Side repeater not working |1.4.A.2c| | 1 |
| Front Windscreen washer control missing |8.2.1a| | 1 |
| Front Windscreen wiper control missing |8.2.1a| | 1 |
| Brake pedal creeps down while the pedal is held under pressure |3.3.B.1a| | 1 |
| Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Bonnet retaining device ineffective |8.4.2| | 1 |
| Nearside Indicator tell tale inoperative |1.4.A.2a| | 1 |
| Nearside Rear Direction indicator not working |1.4.A.2c| | 1 |
| Mechanical brake component has restricted free movement | 1 |
| Brake load sensing valve seized |3.6.E.3| | 1 |
| Offside Driver`s seat cannot be secured in the upright position. |6.2.A.2| | 1 |
| Front Exhaust system not adequately supported |7.1.1| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Body has excessive displacement which may lead to loss of vehicle control |6.1.B.1a| | 1 |
| Offside Rear Body has excessive displacement which may lead to loss of vehicle control |6.1.B.1a| | 1 |
| Horn not working |1.6.2a| | 1 |
| Nearside Rear Hazard warning lamps inoperative |1.4.B.1b| | 1 |
| Offside Rear Hazard warning lamps inoperative |1.4.B.1b| | 1 |
| Offside Front Hazard warning lamps inoperative |1.4.B.1b| | 1 |
| Offside Front Direction indicator not working |1.4.A.2c| | 1 |
| Offside Headlamp aim not tested |1.8.A.1c| | 1 |
| Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Windscreen has damage | 1 |
| Offside Front Steering component mounting prescribed area is excessively corroded floor area |2.2.C.1h| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded floor area |2.4.A.3| | 1 |
| Front brake application uneven | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Suspension component mounting prescribed area fractured significantly reducing structural strength chassie at front spring mount |5.3.6 |a| |i|| | 1 |
| Offside Front Suspension component mounting prescribed area fractured significantly reducing structural strength chassie at front spring mount |5.3.6 |a| |i|| | 1 |
| Nearside Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
| Nearside Rear Direction indicator not working |4.4.1 |a| |ii|| | 1 |
| Brake pedal anti-slip provision worn smooth |3.3.A.1b| | 1 |
| Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Nearside Stop lamp emits other than a steady red light |1.2.1e| | 1 |
| Rear Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Rear Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
| Spare wheel carrier insecure |6.4.2| | 1 |
| Driver`s seat insecure |6.2.A.1| | 1 |
| Bonnet cannot be secured in the closed position |8.4.1| | 1 |
| Nearside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
| Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
| Offside Rear Rear reflector insecure |1.5.1a| | 1 |
| Nearside Inner Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Inner Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Suspension spring mounting prescribed area is inadequately repaired inner foot step (5.3.6 (a) (i)) | 1 |
| Offside Front Inner Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i)) | 1 |
| Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting body mounting (6.2.2 (d) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under body (5.3.6 (a) (i)) | 1 |
| Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
| Nearside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Nearside Rear Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Offside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Offside Rear Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Indicator switch inoperative (4.4.2 (a) (ii)) | 1 |
| Windscreen washer not working | 1 |
| Front Fuel system component leaking (6.1.3 (b) (i)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Indicator switch faulty |1.4.A.1| | 1 |
| Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
| Nearside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
| Offside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
| Offside Front Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Offside Rear Direction indicator not working |4.4.1 |a| |ii|| | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
| Nearside front brake binding |3.7.B.1| | 1 |
| Offside Direction indicator incomplete |1.5.A1b| | 1 |
| Offside Front Brake hose bulging under pressure |3.6.B.3| | 1 |
| Fuel system component insecure |7.2.1| | 1 |
| Offside Front An item not tested |Manual| | 1 |