| Most common failures | No# failures |
|---|
| Registration plate lamp issues | 5 |
| Registration plate issues | 5 |
| Headlamp aim out of alignment | 2 |
| Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Service brake: efficiency below requirements |3.7.B.7| | 2 |
| Parking brake: efficiency below requirements |3.7.B.7| | 2 |
| Spare wheel insecure in carrier (6.1.5 (b) (i)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
| Hazard warning lamps inoperative (4.4.1 (e)) | 1 |
| Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| All direction indicators not working (4.4.1 (a) (ii)) | 1 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Offside Front Headlamp aim not tested (4.1.2 (b)) | 1 |
| Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Front Steering linkage ball joint ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Offside Front Steering linkage ball joint ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Central Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Position lamp not working All position lamps not working (4.2.1 (a) (ii)) | 1 |
| Front brake disc in such a condition that it is seriously weakened | 1 |
| Fuel system component leaking |7.2.3| | 1 |
| Offside Front Brake pedal excessively corroded |3.3.A.1a| | 1 |
| Offside Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
| Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c| | 1 |
| Offside Front Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c| | 1 |
| Horn not working |1.6.2a| | 1 |
| Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Front Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
| Offside Front Drag link end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Nearside Front Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
| Offside Front Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Rear Rear position lamp|s| incomplete |1.1.4a| | 1 |
| Nearside Rear Lower Rear position lamp|s| excessively damaged so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Front Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b| | 1 |
| Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
| Offside Front Seat belt retracting mechanism defective |5.2.5b| | 1 |
| Nearside Rear Lower Stop lamp not working |1.2.1b| | 1 |
| Offside Rear Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Rear Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Offside Rear Stop lamp not working |1.2.1b| | 1 |
| Front Exhaust system not adequately supported |7.1.1| | 1 |
| Offside Front Seat belt buckle missing (7.1.2 (d)) | 1 |
| Nearside Rear Direction indicator not working |1.4.A.2c| | 1 |
| Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded scuttle panel (1.1.21 (e) (i)) | 1 |
| Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Centre Front Statutory seat belt missing |5.1.1| | 1 |
| Electrical wiring insecure rear junction box hanging off |1.9.2a| | 1 |
| Body has a sharp edge caused by damage o/s body panel hanging off |6.1.C.1| | 1 |
| Body insecure and dangerous to other road users o/s wheel arche hanging off |6.1.B.1b| | 1 |
| Brake load sensing valve obviously incorrectly adjusted load valve bushes worn |3.6.E.3| | 1 |
| Exhaust has a major leak of exhaust gases from tail pipe |7.1.2| | 1 |
| Mechanical brake component has restricted free movement | 1 |