Most common failures | No# failures |
---|
Headlamp aim out of alignment | 10 |
Parking brake: efficiency below requirements |3.7.B.7| | 4 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 4 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Battery insecure |1.9.1| | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Windscreen washer not working | 2 |
Indicator switch faulty |1.4.A.1| | 2 |
Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Rear Brake hose twisted |3.6.B.4c| | 1 |
Offside Front Outer Sub-frame pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Nearside Front Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Registration plate issues | 1 |
Horn not working |1.6.2a| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Fuel system component leaking |7.2.3| | 1 |
Offside Front Inner Sub-frame pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Nearside Rear Mechanical brake component locking device missing |3.5.1l| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Brake pedal creeps down while the pedal is held under pressure |3.3.B.1a| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Registration plate lamp issues | 1 |
Driver`s seat fore and aft adjustment mechanism not functioning as intended. |6.2.A.3| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Nearside Headlamp insecure |1.7.3| | 1 |
Offside Headlamp insecure |1.7.3| | 1 |
Offside Front Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Nearside Upper Front suspension has excessive movement at a wishbone pin or bush |2.5.A.1c| | 1 |
An item not tested |Manual| | 1 |
Horn not loud enough to be heard by another road user |1.6.2b| | 1 |
Offside Rear Wheel bolt|s| missing |4.2.A.1e| | 1 |
Fuel cap/sealing device mounting flange/sealing method defective |7.2.4c| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Nearside Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Front Ball joint has excessive play |2.2.B.1f| | 1 |
Rear Exhaust mounting missing |7.1.1b| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill/floor |6.1.B.2| | 1 |
Offside Front Driver`s seat cannot be secured in the upright position. |6.2.A.2| | 1 |
Nearside Front Battery insecure |1.9.1| | 1 |
Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Rear parking brake recording little or no effort | 1 |
Offside Rear Fuel cap/sealing device mounting flange/sealing method defective |7.2.4c| | 1 |
Nearside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Drive shaft which forms part of the suspension coupling gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.4.G.4e| | 1 |
Offside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Rear brake binding | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Offside Rear Brake hose twisted |3.6.B.4c| | 1 |
Offside Inner Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Upper Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Drive shaft which forms part of the suspension coupling gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.4.G.4e| | 1 |