Most common failures | No# failures |
---|
Parking brake: efficiency below requirements |3.7.B.7| | 6 |
Offside Rear fog lamp not working |1.3.2b| | 5 |
Headlamp aim out of alignment | 5 |
Windscreen wiper does not clear the windscreen effectively | 4 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 4 |
Brake pipe excessively corroded | 4 |
Service brake: efficiency below requirements |3.7.B.7| | 4 |
Rear fog lamp tell tale not working |1.3.1b| | 3 |
Rear brake application uneven | 3 |
Brakes imbalanced across an axle | 3 |
Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 3 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 3 |
Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 3 |
Registration plate lamp issues | 2 |
Brake load sensing valve linkage seized |3.6.E.3| | 2 |
Brake hose excessively deteriorated | 2 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Offside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 2 |
Nearside Front Direction indicator incomplete |1.5.A1b| | 2 |
Offside Stop lamp emits other than a steady red light |1.2.1e| | 2 |
Offside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Rear Anti-roll bar attachment bracket/mounting worn and its strength is seriously reduced |2.4.G.1| | 1 |
Fuel pipe leaking |7.2.3| | 1 |
Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Brake cable has wires broken and is significantly weakened |3.5.1b| | 1 |
Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Statutory seat belt missing |5.1.1| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Offside Rear fog lamp insecure |1.3.2a| | 1 |
Rear Rear fog lamp does not face the rear |1.3.2a| | 1 |
Offside Rear Anti-roll bar attachment bracket/mounting insecure |2.4.G.1| | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Nearside Front Brake pipe inadequately clipped |3.6.B.1| | 1 |
Front Exhaust system not adequately supported |7.1.1| | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Exhaust engine idle speed too high |7.3.A.2a| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Offside Front Axle king pin has excessive play in pin and/or bush adversely affecting the steering |2.5.A.3a| | 1 |
Nearside Front front brake grabbing severely |3.7.A.2b| | 1 |
Nearside Front Seat belt retracting mechanism defective |5.2.5b| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Front Drag link end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Rear Lower Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Nearside Rear Lower Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake pedal spongy |3.3.B.1b| | 1 |
Nearside Front Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Upper Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Service brake: efficiency below requirements |3.7.C.1a| | 1 |
Rear fog lamp not working |1.3.2b| | 1 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Emissions not tested |7.0| | 1 |
Offside Headlamp aim aimed so that it dazzles other road users |1.8.A.1a| | 1 |
Rear parking brake recording little or no effort | 1 |
Offside Rear position lamp|s| has less than 50% of the light sources illuminating |1.1.A.3b| | 1 |
Nearside Front Wheel bearing has excessive play requires adjustment (5.1.3 (a) (i)) | 1 |
Offside Front Wheel bearing has excessive play requires adjustment (5.1.3 (a) (i)) | 1 |
Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Rear Upper Direction indicator not working |1.4.A.2c| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Registration plate issues | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Offside Body or chassis is damaged, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Direction indicators not working |1.4.A.2c| | 1 |
Offside Direction indicators not working |1.4.A.2c| | 1 |
Nearside Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
Offside Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |