Most common failures | No# failures |
---|
Brakes imbalanced across an axle | 3 |
Rear Brake load sensing valve linkage seized |3.6.E.3| | 2 |
Rear fog lamp tell tale not working |1.3.1b| | 2 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Offside Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Brake pipe excessively corroded | 1 |
Nearside Front brake disc excessively pitted |3.5.1h| | 1 |
Offside Front brake disc excessively pitted |3.5.1h| | 1 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Centre Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Rear Brake load sensing valve linkage defective and function impaired |3.6.E.3| | 1 |
Exhaust emits an excessive level of metered smoke for a turbo charged engine |7.4.B.3b| | 1 |
Windscreen washer not working | 1 |
Headlamp aim out of alignment | 1 |
Offside Fuel cap/sealing device sealing washer missing |7.2.4c| | 1 |
Offside Fuel cap/sealing device does not fasten securely by positive means |7.2.4b| | 1 |
Rear parking brake recording little or no effort | 1 |
Rear fog lamp not working |1.3.2b| | 1 |
Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Battery insecure |1.9.1| | 1 |
Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Nearside Front Passenger`s seat insecure |6.2.A.1| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front Direction indicators not working |1.4.A.2c| | 1 |
Nearside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Front Axle king pin has excessive play in pin and/or bush adversely affecting the steering |2.5.A.3a| | 1 |
Steering box has relative movement between sector shaft and the drop arm |2.2.B.1b| | 1 |
Nearside Parking brake is not capable of being maintained in operation by direct mechanical action only |3.1.2| | 1 |
Offside Parking brake is not capable of being maintained in operation by direct mechanical action only |3.1.2| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |