Most common failures | No# failures |
---|
Brakes imbalanced across an axle | 6 |
Service brake: efficiency below requirements |3.7.B.7| | 5 |
Offside Headlamp not working on dipped beam |1.7.5a| | 3 |
Horn not working |1.6.2a| | 3 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Offside rear brake recording little or no effort |3.7.B.5a| | 2 |
Brake pipe excessively corroded | 2 |
Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 2 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 2 |
Brake hose excessively deteriorated | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Offside front brake binding |3.7.B.1| | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Front Exhaust system not adequately supported |7.1.1| | 1 |
Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
Brake performance not tested |3.7.A.1| | 1 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Trailer electrical socket insecure |1.9.3a| | 1 |
Nearside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Front brake application uneven | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Rear Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Nearside Front Brake pipe leaking |3.6.A.1| | 1 |
Centre Exhaust mounting missing |7.1.1b| | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Nearside Rear Parking |secondary brake| on a single line braking system has inadequate effort at a wheel Low reading to park brake. |1.3.1 |a| |i|| | 1 |
Offside Rear Stop lamp|s| not working And tail lamp goes dim when foot brake applied. |4.3.1 |a| |ii|| | 1 |
Offside Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
Offside Rear Direction indicator not working |4.4.1 |a| |ii|| | 1 |
Undertray likely to become detached Tray holding gas bottle up, mounting bracket on body corroded and snapping. |6.2.1 |a| |ii|| | 1 |
Offside Body insecure Drivers door step holed, corroded, and insecure. |6.2.2 |a| |i|| | 1 |
Offside Front Suspension component mounting prescribed area is inadequately repaired Welded plate not fully welded. |5.3.6 |a| |i|| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner wheel arch by top shock mounting. |5.3.6 |a| |i|| | 1 |
Offside Front Suspension component mounting prescribed area so inadequately repaired that control of the vehicle is likely to be adversely affected inner wheel arch |5.3.6 |a| |ii|| | 1 |
Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected inner wheel arch |5.3.6 |a| |ii|| | 1 |
Offside Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
Offside Rear Position lamp adversely affected by the operation of another lamp |4.2.3 |c|| | 1 |
Offside Position lamp not working high level |4.2.1 |a| |ii|| | 1 |
Rear fog lamp not working |1.3.2b| | 1 |
Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Front front brake recording little or no effort |3.7.B.5a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Rear brake application uneven | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Registration plate lamp issues | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Fuel system component leaking |7.2.3| | 1 |
Emissions not tested there is no abnormal engine noise belt insecure |7.4.B.1| | 1 |
Nearside Front Axle king pin has excessive play in pin and/or bush adversely affecting the steering |2.5.A.3a| | 1 |
Offside Front Lower Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Front Fuel pipe leaking |7.2.3| | 1 |