| Most common failures | No# failures |
|---|
| Parking brake: efficiency below requirements |3.7.B.7| | 6 |
| Registration plate lamp issues | 5 |
| Registration plate issues | 4 |
| Offside Stop lamp not working |1.2.1b| | 4 |
| Brake pipe excessively corroded | 4 |
| Service brake: efficiency below requirements |3.7.B.7| | 3 |
| Brake hose excessively deteriorated | 3 |
| Exhaust emits an excessive level of metered smoke for a turbo charged engine |7.4.B.3b| | 2 |
| Nearside Front Track rod end ball joint has excessive play |2.2.B.1f| | 2 |
| Rear fog lamp switch missing |1.3.1a| | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Nearside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 2 |
| Rear parking brake recording little or no effort | 2 |
| Offside Rear Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 2 |
| Nearside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 2 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
| Offside Suspension component mounting prescribed area is excessively corroded outter middle sill holed |2.4.A.3| | 1 |
| Nearside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
| Nearside Front Lower Ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Windscreen has damage | 1 |
| Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
| Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
| Rear Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
| Rear fog lamp switch faulty |1.3.1a| | 1 |
| Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
| Nearside Passenger`s seat insecure |6.2.A.1| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Brake cable has wires broken and is significantly weakened |3.5.1b| | 1 |
| Nearside front brake binding |3.7.B.1| | 1 |
| Offside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Rear fog lamp switch insecure |1.3.1a| | 1 |
| Centre Parking brake lever has no reserve travel cable fried |3.1.6b| | 1 |
| Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings shill holed |6.1.B.2| | 1 |
| Nearside Front Ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Rear Rear wheel bearing has excessive play |2.6.2| | 1 |
| Front brake excessively fluctuating | 1 |
| rear brake excessively fluctuating |3.7.B.3| | 1 |
| Rear brake application uneven | 1 |
| Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Brake pedal creeps down while the pedal is held under pressure |3.3.B.1a| | 1 |
| Brake relay lever has restricted free movement |3.5.1k| | 1 |
| Brake load sensing valve has been removed and was fitted as standard |3.6.E.2| | 1 |
| Offside Front Body has a sharp edge caused by corrosion door sharp edge |6.1.C.1| | 1 |
| Front wheel bearing has excessive play |2.5.A.3c| | 1 |
| Front brake application uneven | 1 |
| Passenger`s seat insecure |6.2.A.1| | 1 |
| Offside Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
| Front Headlamp aim projected beam image is obviously incorrect both, lens defective (4.1.2 (c)) | 1 |
| Nearside Rear Lower Shock absorbers has an excessively worn bush (5.3.2 (c)) | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded sill holed and distorted |2.4.A.3| | 1 |
| Nearside Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Offside Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
| Nearside Rear Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |