Most common failures | No# failures |
---|
Headlamp aim out of alignment | 9 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 7 |
Offside Rear fog lamp not working |1.3.2b| | 7 |
Exhaust has a major leak of exhaust gases |7.1.2| | 6 |
Parking brake: efficiency below requirements |3.7.B.7| | 5 |
Brake pipe excessively corroded | 5 |
Windscreen wiper does not clear the windscreen effectively | 4 |
Offside Stop lamp not working |1.2.1b| | 4 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 4 |
Service brake: efficiency below requirements |3.7.B.7| | 3 |
Rear fog lamp not working |1.3.2b| | 3 |
Rear fog lamp tell tale not working |1.3.1b| | 3 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Nearside Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a| | 2 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 2 |
Rear parking brake recording little or no effort | 2 |
Registration plate lamp issues | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 2 |
Parking brake lever has no reserve travel |3.1.6b| | 2 |
Offside Rear Rear fog lamp not working |1.3.2b| | 2 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 2 |
Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 2 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 2 |
Nearside Side repeater not working |1.4.A.2c| | 2 |
Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 2 |
Offside Rear Brake pipe leaking |3.6.A.1| | 2 |
Brakes imbalanced across an axle | 2 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 2 |
Windscreen has damage | 2 |
Brake pedal creeps down while the pedal is held under pressure |3.3.B.1a| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Nearside Brake hose twisted |3.6.B.4c| | 1 |
Brake hose excessively deteriorated | 1 |
Offside Front Brake hose leaking |3.6.A.1| | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Nearside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Offside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Rear fog lamp tell-tale not working |4.9.1 |a| |ii|| | 1 |
Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
Exhaust has a major leak of exhaust gases |6.1.2 |a|| | 1 |
Emissions not tested |8.2.2.2 |e|| | 1 |
Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch within 30cm of suspension mounting |5.3.6 |a| |i|| | 1 |
Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch with 30cm suspension mounting |5.3.6 |a| |i|| | 1 |
Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering Front of chassis near steering box (6.1.1 (c) (ii)) | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Obligatory mirror is incapable of being adjusted to provide an adequate view to the rear |8.1.2b| | 1 |
Nearside Obligatory mirror is incapable of being adjusted to provide an adequate view to the rear |8.1.2b| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Brake load sensing valve linkage obviously incorrectly adjusted |3.6.E.3| | 1 |
Nearside Rear Direction indicator adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
Offside Rear Direction indicator adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Offside Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c| | 1 |
Main beam `tell-tale` not working |1.7.4c| | 1 |
Nearside Front Headlamp not working on main beam |1.7.5a| | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Fuel cap/sealing device does not fasten securely by positive means |7.2.4b| | 1 |
Centre Upper Rear position lamp|s| not working |1.1.A.3b| | 1 |
Upper Rear position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Registration plate issues | 1 |
Rear brake binding | 1 |
Rear brake application uneven | 1 |
rear brakes release unevenly |3.7.B.4| | 1 |
Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded bulkhead (1.1.21 (e) (i)) | 1 |
Exhaust system insecure (6.1.2 (a)) | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Front Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Offside Rear wheel cylinder leaking |3.6.A.1| | 1 |
Brake pedal has insufficient reserve movement |3.3.A.5| | 1 |
Offside Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a| | 1 |
Nearside Rear wheel bearing has excessive play |2.6.2| | 1 |
Centre Bonnet retaining device ineffective safety catch missing |8.4.2| | 1 |
Offside Rear fog lamp missing |4.5.1 |a| |ii|| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Offside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Side repeater incorrect colour |1.4.A.2f| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake load sensing valve linkage defective and function impaired |3.6.E.3| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Nearside Front brake disc excessively pitted |3.5.1h| | 1 |
Nearside Lower Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Fuel system component insecure |7.2.1| | 1 |
Fuel cap/sealing device sealing washer missing |7.2.4c| | 1 |
Nearside Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected |5.3.6 |a| |ii|| | 1 |
Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b| | 1 |
Offside Front Side repeater not working |1.4.A.2c| | 1 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Rear fog lamp missing |1.3.2a| | 1 |
Brake load sensing valve seized |3.6.E.3| | 1 |
Rear fog lamp insecure |1.3.2a| | 1 |
Offside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Nearside Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Front Body insecure and dangerous to other road users |6.1.B.1b| | 1 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Bonnet retaining device ineffective |8.4.2| | 1 |
Front passenger door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Lower Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Drag link end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Front Drag link end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Nearside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Fuel cap/sealing device sealing washer deteriorated |7.2.4c| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |