>

MOT History from tests of petrol MERCEDES BENZ 208s year 1982

Review the list of common MERCEDES BENZ 208 failures below or to perform a specific mot history check on your MERCEDES BENZ then use our popular KnowYourCar service

mot history
Pass percent:60.61%
(The average a petrol MERCEDES BENZ 208 year 1982 passes without issue)
Based on:99 MOT Tests
Most common failuresNo# failures
Headlamp aim out of alignment13
Windscreen wiper does not clear the windscreen effectively8
Service brake: efficiency below requirements |3.7.B.7|7
Brakes imbalanced across an axle7
Registration plate lamp issues6
Rear fog lamp not working |1.3.2b|5
Offside Rear fog lamp not working |1.3.2b|5
Exhaust emissions hydrocarbon content excessive |7.3.B.1b|4
Exhaust emissions carbon monoxide content excessive |7.3.B.1a|4
Exhaust has a major leak of exhaust gases |7.1.2|4
Exhaust system not adequately supported |7.1.1|3
Nearside Front Direction indicator not working |1.4.A.2c|3
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3|3
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3|3
Brake pipe excessively corroded3
Rear brake application uneven3
Hazard warning lamps inoperative |1.4.B.1b|3
Parking brake lever has no reserve travel |3.1.6b|3
Nearside Side repeater not working |1.4.A.2c|3
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b|3
Nearside rear brake recording little or no effort |3.7.B.5a|3
Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3|2
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3|2
Indicator switch faulty |1.4.A.1|2
Parking brake: efficiency below requirements |3.7.B.7|2
Front brake application uneven2
Rear Exhaust system not adequately supported |7.1.1|2
Offside Stop lamp not working |1.2.1b|2
Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3|2
Brake hose excessively deteriorated2
Offside rear brake recording little or no effort |3.7.B.5a|2
Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced step, visible from inside the vehicle and the underside (6.1.1 (c) (i))1
Nearside Rear Exhaust system insecure (6.1.2 (a))1
Nearside Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))1
Offside Front Exhaust has a major leak of exhaust gases (6.1.2 (a))1
Horn not working (7.7 (a) (ii))1
Offside Rear fog lamp not working (4.5.1 (a) (ii))1
Windscreen wiper not working both (3.4 (a))1
Rear Rear fog lamp not working |1.3.2b|1
Offside Front Driver`s door cannot be opened from outside the vehicle |6.2.B.1b|1
Exhaust engine idle speed too high |7.3.A.2a|1
Direction indicators flashing more than 120 times a minute |1.4.A.2g|1
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f|1
Offside front brake binding |3.7.B.1|1
Offside Front position lamp|s| not working |1.1.A.3b|1
Brake load sensing valve linkage seized |3.6.E.3|1
Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1|1
Offside Front Body has a sharp edge caused by corrosion |6.1.C.1|1
Brake pedal spongy |3.3.B.1b|1
Nearside Front position lamp|s| not working |1.1.A.3b|1
Centre Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e|1
Nearside Rear Shock absorber has negligible damping effect |2.7.5|1
Offside Rear Shock absorber has negligible damping effect |2.7.5|1
Centre Exhaust system not adequately supported |7.1.1|1
Offside Inner Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3|1
Offside Driver`s door cannot be opened from outside the vehicle |6.2.B.1b|1
Rear fog lamp tell tale not working |1.3.1b|1
Horn not working |1.6.2a|1
Nearside Stop lamp not working |1.2.1b|1
Position lamp not working all side lights not working (4.2.1 (a) (ii))1
Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b|1
Brake pedal creeps down when held under pressure |3.3.B.1a|1
Nearside Front Front position lamp|s| not working |1.1.A.3b|1
Nearside Rear Rear position lamp|s| not working |1.1.A.3b|1
Windscreen washer not working 1
All direction indicators not working (4.4.1 (a) (ii))1
Front position lamp|s| not working |1.1.A.3b|1
Headlamp aim beam image obviously incorrect both lamps |1.8.A.1b|1
Passengers seat insecure (6.2.6 (a) (ii))1
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b|1
Offside Rear reflector excessively damaged so that its function is impaired |1.5.1c|1
Battery insecure and likely to cause a short circuit (4.13 (a) (ii))1
Hazard warning switch faulty |1.4.B.1d|1
Direction indicators adversely affected by the operation of another lamp |1.4.A.2h|1
Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f|1
Nearside Front Side repeater not working |1.4.A.2c|1
Service brake: efficiency below requirements |3.7.C.1a|1
Parking brake: efficiency below requirements |3.7.C.1b|1
Fuel hose leaking |7.2.3|1
Offside Steering component mounting prescribed area is excessively corroded |2.2.C.1h|1
Offside Front Suspension spring mounting prescribed area is severely distorted |2.4.A.3|1
Offside Front brake disc excessively pitted |3.5.1h|1
Nearside Front brake disc excessively pitted |3.5.1h|1
Offside Front front brake recording little or no effort |3.7.B.5a|1
Bonnet cannot be secured in the closed position (3.1 (b) (i))1
Stop lamp not working |1.2.1b|1
Service brake efficiency below requirements (1.2.2 (a) (i))1
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))1
Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced step, visible from inside the vehicle and the underside (6.1.1 (c) (i))1
Offside Front Brake pipe inadequately supported |3.6.B.1|1
Offside Front Brake pipe inadequately supported Due to corrosion around Union mounting |3.6.B.1|1
Offside Front Steering component mounting prescribed area is excessively corroded Within steering box area |2.2.C.1h|1
Offside Rear fog lamp missing |1.3.2a|1
Nearside Front Headlamp not working on dipped beam |1.7.5a|1
Nearside Headlamp not working on main beam |1.7.5a|1
Nearside Front Direction indicator incorrect colour Lens damaged showing white light |1.4.A.2f|1
Offside Rear Stop lamp not working |1.2.1b|1
Offside Rear Direction indicator not working |1.4.A.2c|1
Rear fog lamp switch missing |1.3.1a|1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy