| Most common failures | No# failures |
|---|
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
| Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 2 |
| Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Engine MIL inoperative or indicates a malfunction Constantly illuminated. (8.2.1.2 (h)) | 1 |
| Electronic stability control warning lamp indicates a fault VSC warning constantly illuminated (7.12 (e)) | 1 |
| Windscreen washer not working | 1 |
| Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Offside Front Headlamp aim not tested (4.1.2 (b)) | 1 |
| Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Offside Rear Service brake excessively fluctuating (1.2.1 (e)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Nearside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
| Offside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
| Brake lever has insufficient reserve travel (1.1.2 (a)) | 1 |
| Hydraulic brake cylinder operating mechanism has excessive travel (1.1.16 (e) (i)) | 1 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
| Brakes imbalanced across an axle | 1 |
| Nearside Front Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
| Offside Front Track rod end ball joint worn to the extent there is a serious risk of detachment (2.1.3 (b) (ii)) | 1 |
| Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
| Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b)) | 1 |
| Anti-lock braking system warning lamp indicates an ABS fault | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Front Headlamp aim projected beam image is obviously incorrect conversion stickers applied (4.1.2 (c)) | 1 |