Most common failures | No# failures |
---|
Registration plate lamp issues | 5 |
Parking brake: efficiency below requirements |3.7.B.7| | 4 |
Windscreen wiper does not clear the windscreen effectively | 4 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 3 |
Offside Stop lamp not working |1.2.1b| | 2 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 2 |
Parking brake lever has no reserve travel |3.1.6b| | 2 |
Anti-lock braking system warning lamp indicates an ABS fault | 2 |
Nearside Front Steering locking device missing |2.2.C.1g| | 1 |
Offside Steering locking device missing |2.2.C.1g| | 1 |
Nearside Rear coil spring incomplete |2.4.C.1a| | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Nearside Front Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a| | 1 |
Nearside Rear Lower Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Front Front suspension has excessive play in a upper suspension ball joint top wishbone arm |2.5.B.1a| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Offside Rear position lamp|s| has less than 50% of the light sources illuminating |1.1.A.3b| | 1 |
Nearside Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Supplementary restraint system warning lamp indicates a fault (7.1.6 (a)) | 1 |
Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
Nearside Front Lower Suspension arm attachment bracket/mounting insecure lower bottom ball joint bolt loose (5.3.3 (a) (i)) | 1 |
Nearside Rear Service brake excessively fluctuating (1.2.1 (e)) | 1 |
Boot lid cannot be secured in the closed position (6.2.1 (e)) | 1 |
Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
Nearside Track rod end ball joint has excessive play Insecure at lock nut (2.1.3 (b) (i)) | 1 |
Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Front of both rear arches (5.3.6 (a) (i)) | 1 |
Bonnet cannot be secured in the closed position (3.1 (b) (i)) | 1 |
Nearside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced o/s/r (6.1.1 (c) (i)) | 1 |