| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 6 |
| Brakes imbalanced across an axle | 3 |
| Registration plate issues | 2 |
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
| Service brake: efficiency below requirements |3.7.B.7| | 2 |
| Offside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
| Front Windscreen wiper not working Both windscreen wipers are not working (3.4 (a)) | 1 |
| Windscreen washer not working | 1 |
| Offside Front Seat belt not functioning as intended Seat belt does not retract (7.1.2 (c)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
| Nearside Rear Leaf spring shackle pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Rear Leaf spring shackle pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Nearside Front Lower Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting bulkhead (6.2.2 (d) (i)) | 1 |
| Nearside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Rear Mechanical brake component has restricted free movement | 1 |
| All direction indicators not working ALL Direction indicators do not flash as required. (4.4.1 (a) (ii)) | 1 |
| Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
| Offside Rear Road wheel spoke corroded |4.2.A.1b| | 1 |
| Front brake excessively fluctuating | 1 |
| Offside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
| Registration plate lamp issues | 1 |
| Mechanical brake component has restricted free movement | 1 |
| Offside Front Upper Brake master cylinder/servo mounting prescribed area is excessively corroded bulkhead |3.6.C.3| | 1 |
| Offside Front Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings lower bulkhead |6.1.B.2| | 1 |
| Offside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings bulkhead |6.1.B.2| | 1 |
| Nearside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings lower bulkhead |6.1.B.2| | 1 |
| Offside Front Body has a sharp edge caused by corrosion bumper |6.1.C.1| | 1 |
| Nearside Front Seat belt not functioning as intended |7.1.2 |c|| | 1 |
| Offside Front Seat belt not functioning as intended |7.1.2 |c|| | 1 |
| Stop lamp|s| all missing |4.3.1 |a| |iii|| | 1 |
| Oil leaking excessively from engine |8.4.1 |a| |i|| | 1 |