Most common failures | No# failures |
---|
Rear fog lamp not working |1.3.2b| | 5 |
Headlamp aim out of alignment | 5 |
Rear fog lamp tell tale not working |1.3.1b| | 2 |
Headlamp not working on dipped beam |1.7.5a| | 2 |
Registration plate lamp issues | 2 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
Main beam `tell-tale` not working |1.7.4c| | 2 |
Nearside Rear Service brake excessively binding (1.2.1 (f)) | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Upper Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Rear Upper Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
All position lamps not working |1.1.A.3b| | 1 |
Nearside Rear Upper Tie bar/rod has excessive play in a pin/bearing |2.4.G.2| | 1 |
Offside Rear Upper Tie bar/rod has excessive play in a pin/bearing |2.4.G.2| | 1 |
Speedometer cannot be illuminated. |6.7.3| | 1 |
Headlamp not working on main beam |1.7.5a| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Nearside Front Direction indicator not working |1.4.A.2c| | 1 |
Nearside Direction indicator flashing more than 120 times a minute |1.4.A.2g| | 1 |
Stop lamp not working |1.2.1b| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake pipe excessively corroded | 1 |
Offside Rear Radius arm has excessive play in a ball joint |2.4.G.2| | 1 |
Brake pedal spongy |3.3.B.1b| | 1 |
Nearside Front Service brake excessively binding |1.2.1 |f|| | 1 |
Offside Rear Service brake excessively binding |1.2.1 |f|| | 1 |
Nearside Rear Brake hose excessively twisted |1.1.12 |b| |ii|| | 1 |
Offside Rear Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake performance not tested (1.2.1 (g)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Nearside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
Registration plate issues | 1 |
Nearside Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
Offside Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
Nearside Front Seat belt retracting mechanism defective |7.1.2 |e|| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Rear Shock absorber has a serious fluid leak front shock |2.7.3| | 1 |
Rear brake binding | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Nearside Rear Lower Suspension arm has excessive play in a pin/bearing |2.4.G.2| | 1 |
Offside Rear Lower Suspension arm has excessive play in a pin/bearing |2.4.G.2| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
Offside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Horn not working |1.6.2a| | 1 |
Offside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
Offside Front Direction indicator not working |1.4.A.2c| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Rear parking brake recording little or no effort | 1 |
Nearside Front Headlamp not working on main beam |1.7.5a| | 1 |
Offside Rear Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Rear Upper Tie bar/rod has excessive play in a pin/bush |2.4.G.2| | 1 |