| Most common failures | No# failures |
|---|
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Brake pipe excessively corroded | 3 |
| Headlamp aim out of alignment | 2 |
| Brakes imbalanced across an axle | 2 |
| Brake hose excessively deteriorated | 2 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 2 |
| Rear parking brake recording little or no effort | 2 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Rear Fuel hose leaking |7.2.3| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Obligatory mirror missing |8.1.1| | 1 |
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
| Nearside Rear All position lamps not working |1.1.A.3b| | 1 |
| Offside Rear All position lamps not working |1.1.A.3b| | 1 |
| Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
| Rear Exhaust has a part missing |7.1.1a| | 1 |
| Steering rack gaiter split |2.2.D.2d| | 1 |
| Hazard warning switch faulty |1.4.B.1d| | 1 |
| Nearside Side repeater not working |1.4.A.2c| | 1 |
| Upper Rear passenger seat cannot be secured in the upright position. |6.2.3| | 1 |
| Centre Steering rack gaiter split |2.2.D.2d| | 1 |
| Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Outer Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Obligatory mirror insecure |8.1.1| | 1 |
| Offside Outer Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b| | 1 |
| Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Outer Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Inner Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Outer Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Dipswitch operation does not extinguish all main beam headlamps leaving at least one pair of dipped beam headlamps |1.7.4b| | 1 |
| Parking brake lever ratchet mechanism is excessively worn |3.1.5| | 1 |
| Nearside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Nearside Front Brake hose twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |