Most common failures | No# failures |
---|
Headlamp aim out of alignment | 10 |
Horn not working |1.7.3a| | 4 |
Front Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 3 |
Drive chain excessively loose |6.2.1d| | 2 |
Drive chain excessively loose |6.1.7 |c| |i|| | 2 |
Nearside Handlebar handgrip not secure to handlebars. |2.1.1c| | 2 |
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 2 |
Throttle operating incorrectly |6.2.1f| | 2 |
Drive chain excessively loose (6.1.7 (c) (i)) | 2 |
Nearside Front Footrest insecure |6.2.1a| | 2 |
Nearside Rear Drive chain excessively tight |6.2.1d| | 1 |
Brake hose is likely to be fouled or trapped by moving parts Front hoses insecure |3.2.B2c| | 1 |
Front wheel spindle loose Front wheel loose |2.3.5a| | 1 |
Stop lamp does not illuminate immediately a brake applies Rear brake light in op |1.3.1a| | 1 |
Steering control fouling between components which interferes with the free movement of the steering Handlebars hitting fairing on full lock |2.1.2a| | 1 |
Exhaust mounting does not fully support the exhaust system Exhaust bracket under engine corroded loose |7.1.1.c| | 1 |
Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 1 |
Steering movement excessively `notchy` with the weight on the lower bearing |2.2.1a| | 1 |
Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 1 |
Offside Front Lower Front mudguard insecure |2.3.7| | 1 |
Offside Rear Footrest missing |6.2.1a| | 1 |
Registration plate lamp issues | 1 |
Front Brake excessively binding |1.2.1 |f|| | 1 |
Drive chain so loose it is likely to fail |6.1.7 |c| |ii|| | 1 |
Offside Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Rear Brake lining(s) less than 1.0 mm thick (1.1.13 (a)) | 1 |
Drive chain excessively tight |6.2.1d| | 1 |
Front Stop lamp not working (4.3.1 (a) (ii)) | 1 |
Nearside Front Footrest insecure (6.2.12 (a)) | 1 |
Rear Roller brake test indicates brake effort fall disproportional to brake lever or pedal effort |3.3.A1c| | 1 |
Nearside Front Handlebar grip insecure to handlebar (2.2.1 (d) (ii)) | 1 |
Front Valve stem seriously damaged (5.2.3 (j)) | 1 |
Drive chain worn to excess (6.1.7 (c) (i)) | 1 |
Rear Brake master cylinder defective but brake still operating |1.1.10 |b| |i|| | 1 |
Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Nearside Front Shock absorber has a serious fluid leak |5.3.2 |b|| | 1 |
Rear Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 1 |
Brake pedal has inadequate reserve travel |3.1.3b| | 1 |
Throttle operating incorrectly not secure to handlebars |6.2.1f| | 1 |
Nearside Front Brake disc|s| has excessive run out |3.2.A1m| | 1 |
Offside Front Brake disc|s| has excessive run out |3.2.A1m| | 1 |
Front Roller brake test indicates excessive fluctuation of brake effort |3.3.A1d| | 1 |
Rear Locking device|s| not correctly fitted which may make the motor bicycle dangerous to ride split pin missing from rear wheel shaft |6.2.1h| | 1 |
Rear Drive chain sprocket worn to excess |6.2.1e| | 1 |