Most common failures | No# failures |
---|
Headlamp aim out of alignment | 5 |
Steering headbearing has excessive free play |2.2.2| | 5 |
Nearside Front shock absorber seal failed and leaking oil |2.3.3| | 3 |
Front wheel bearings are excessively rough |2.3.5b| | 3 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 3 |
Rear Brake lever has inadequate reserve travel |3.1.3b| | 3 |
Exhaust is leaking and excessively noisey |7.1.1b| | 2 |
Front Brake fluid reservoir fluid level dangerously low |3.2.B1d| | 2 |
Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 2 |
Rear Stop lamp remains on when the brake is released |1.3.1e| | 1 |
Offside Rear shock absorber seal failed and leaking oil |2.4.A.1c| | 1 |
Front suspension has inadequate damping effect. |2.3.6c| | 1 |
Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Front Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Front wheel bearings have excessive free play |2.3.5b| | 1 |
Rear Brake lever is damaged and the brake cannot be readily applied |3.1.3c| | 1 |
Rear reflector on motorcycle missing |1.4.1| | 1 |
Suspension component ball joint excessively worn ENGINE MOUNTING BUSHES |5.3.4 |a| |i|| | 1 |
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 1 |
Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
Rear Stop lamp not working (4.3.1 (a) (ii)) | 1 |
Front Shock absorber has a serious fluid leak (5.3.2 (b)) | 1 |
Rear Valve stem seriously damaged (5.2.3 (j)) | 1 |
Direction indicators flashing less than 60 times a minute |1.5.1c| | 1 |
Front Stop lamp remains on when the brake is released |1.3.1e| | 1 |
Stop lamp switch with a delay in operation Rear brake. |4.3.2 |a| |ii|| | 1 |
Brake lever has inadequate reserve travel |3.1.3b| | 1 |
Horn control not functioning. |1.7.2b| | 1 |
Front Hydraulic brake control creeps under load. |3.1.4a| | 1 |
Offside Front position lamp does not illuminate immediately when switched on |1.1.3a| | 1 |
Fairing insecure and likely to impede the steering |2.1.2e| | 1 |
Rear Brake lever insecure |3.1.2a| | 1 |
Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2| | 1 |
Rear Rear wheel bearings have excessive free play |2.4.A.2c| | 1 |
Offside Rear Lower Exhaust is leaking and excessively noisey |7.1.1b| | 1 |
Nearside Front Upper Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Nearside Front Lower Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Centre Rear Lower Rear wheel bearings have excessive free play |2.4.A.2c| | 1 |
Offside Rear Lower Brake caliper|s| insecure |3.2.A1j| | 1 |
Offside Rear Brake reaction bracket insecure |3.2.A1j| | 1 |
Front Direction indicator incorrect colour both sides |1.5.1b| | 1 |
Rear Direction indicator incorrect colour both sides |1.5.1b| | 1 |
Rear Brake caliper|s| insecure |3.2.A1j| | 1 |
Stop lamp remains on when the brake is released |1.3.1e| | 1 |
Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Offside Rear Direction indicator not working |1.5.1c| | 1 |
Nearside Front Direction indicators not working |1.5.1c| | 1 |
Rear Brake linkage has abnormal movement due to maladjustment brake plate lever incorrectly fitted |3.2.A1i| | 1 |
Indicator switch defective |1.5.4| | 1 |
Offside Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Roller brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.A2b| | 1 |
Fairings insecure and likely to impede the steering |2.1.2e| | 1 |