| Most common failures | No# failures |
|---|
| Registration plate lamp issues | 4 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 2 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Offside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Inner Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Inner Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Windscreen has damage | 1 |
| Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Brake pipe excessively corroded | 1 |
| Brakes imbalanced across an axle | 1 |
| Offside Side repeater not working (4.4.1 (a) (ii)) | 1 |
| Nearside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c)) | 1 |
| Nearside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 1 |
| Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i)) | 1 |
| Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) | 1 |
| Nearside Rear Parking brake inoperative on one side off side low effort (1.4.1 (a)) | 1 |
| Rear Service brake effort inadequate at a wheel both sides (1.2.1 (a) (i)) | 1 |
| Nearside Rear Service brake grabbing severely |3.7.C.2| | 1 |
| All position lamps not working |1.1.A.3b| | 1 |
| Battery insecure |1.9.1| | 1 |
| Offside Front Direction indicators not working |1.4.A.2c| | 1 |
| Speedometer cannot be illuminated. |6.7.3| | 1 |
| Speedometer clearly inoperative |6.7.2| | 1 |