Most common failures | No# failures |
---|
Parking brake: efficiency below requirements |3.7.B.7| | 18 |
Headlamp aim out of alignment | 10 |
Windscreen wiper does not clear the windscreen effectively | 10 |
Registration plate lamp issues | 9 |
Horn not working |1.6.2a| | 5 |
Anti-lock braking system warning lamp indicates an ABS fault | 4 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 3 |
Rear parking brake recording little or no effort | 3 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 3 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 3 |
Rear Exhaust system not adequately supported |7.1.1| | 2 |
Parking brake efficiency below requirements |1.4.2 |a| |i|| | 2 |
Nearside Side repeater incorrect colour |1.4.A.2f| | 2 |
Offside Side repeater incorrect colour |1.4.A.2f| | 2 |
Offside Front front brake binding |3.7.B.1| | 2 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
Nearside Rear Direction indicator incorrect colour (4.4.3 (a)) | 2 |
Brake master cylinder/servo mounting prescribed area is excessively corroded (1.1.21 (e) (i)) | 2 |
Parking brake: efficiency below requirements (3.7.B.7) | 2 |
Nearside Stop lamp not working |1.2.1b| | 2 |
Brake fluid warning lamp illuminated |3.6.G.2| | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Parking brake lever has no reserve travel |3.1.6b| | 2 |
Nearside Front Seat belt damaged sufficient to obstruct correct operation of the belt |5.2.2a| | 2 |
Exhaust system not adequately supported |7.1.1| | 2 |
Rear Rear fog lamp not working |1.3.2b| | 2 |
Rear Mechanical brake component has restricted free movement | 2 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Offside Front Side repeater excessively damaged so that it is not visible from a reasonable distance |1.4.A.2e| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings body support as marked |6.1.B.2| | 1 |
Offside Exhaust has a major leak of exhaust gases tail pipe from final box |7.1.2| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Lower Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Rear Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Nearside Rear Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
Nearside Front Lower Suspension arm ball joint excessively worn |5.3.4 |a| |i|| | 1 |
Central Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Front Crossmember excessively corroded |bolt on| |5.3.6 |a| |i|| | 1 |
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner Wheel Arch |6.2.2 |d| |i|| | 1 |
Offside Front Lower Trailing arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Rear Anti-roll bar synthetic bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Rear Anti-roll bar synthetic bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Brake pedal spongy |3.3.B.1b| | 1 |
Front brake application uneven | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
rear brakes release unevenly |3.7.B.4| | 1 |
Brakes imbalanced across an axle | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Horn not working (7.7 (a)) | 1 |
Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Exhaust emissions exceed manufacturers specified limit (8.2.2.2 (a)) | 1 |
Nearside Rear Brake disc contaminated (1.1.14 (b)) | 1 |
Nearside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Windscreen washer not working | 1 |
Nearside Side repeater not working (4.4.1 (a) (ii)) | 1 |
Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i)) | 1 |
Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f)) | 1 |
Brake fluid warning lamp illuminated (3.6.G.2) | 1 |
Offside Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b) | 1 |
Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b)) | 1 |
Offside Side repeater incorrect colour (4.4.3 (a)) | 1 |
Nearside Front Direction indicator incorrect colour (4.4.3 (a)) | 1 |
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b) | 1 |
Offside Front Track rod end ball joint has excessive play (2.2.B.1f) | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under bonnet (5.3.6 (a) (i)) | 1 |
Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Windscreen has damage | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Nearside Rear Leaf spring has excessive wear in a shackle pin and/or bush eye bushes |2.4.B.2| | 1 |
Battery insecure |1.9.1| | 1 |
Bonnet retaining device ineffective |8.4.2| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Front Body has a projection caused by corrosion |6.1.C.1| | 1 |
Offside Front Body has a projection caused by corrosion |6.1.C.1| | 1 |
Nearside Inner Rear Body has a projection caused by corrosion |6.1.C.1| | 1 |
Offside Inner Body has a projection caused by corrosion |6.1.C.1| | 1 |
Nearside Rear brake caliper has restricted free movement |3.5.1k| | 1 |
Nearside Rear Inner Body has a projection caused by corrosion panel |6.1.C.1| | 1 |
Nearside Rear Body has a sharp edge caused by damage floor |6.1.C.1| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Side repeater not working |1.4.A.2c| | 1 |
Rear brake caliper has restricted free movement |3.5.1k| | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Front Upper Suspension arm ball joint excessively worn outer (5.3.4 (a) (i)) | 1 |
Offside Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Exhaust emissions test aborted because smoke levels are significantly in excess of the specified limit values |8.2.2.2 |f|| | 1 |
Nearside Front Suspension arm corroded and seriously weakened |5.3.3 |b| |i|| | 1 |
Offside Front Suspension arm corroded and seriously weakened |5.3.3 |b| |i|| | 1 |
Central Prop shaft bearing excessively worn |6.1.7 |b| |i|| | 1 |
Hazard warning switch inoperative |4.4.2 |a| |ii|| | 1 |
Nearside Front Side repeater incorrect colour |1.4.A.2f| | 1 |
Offside Front Side repeater incorrect colour |1.4.A.2f| | 1 |
Rear Exhaust tailpipe not capable of allowing the emission probe to be inserted |7.4.B.1| | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Offside Direction indicator incorrect colour repeater (4.4.3 (a)) | 1 |
Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sills both sides (6.2.2 (d) (i)) | 1 |
Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Rear Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting axle/sub frame (6.2.2 (d) (i)) | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Anti-roll bar insecure |2.4.G.1| | 1 |
Anti-roll bar linkage has excessive play in a pin/bush x4 rear D bushes |2.4.G.2| | 1 |
Offside Front Lower Shock absorber insecure shocker mount snapped |2.7.2b| | 1 |
Nearside Fuel system component leaking fuel leak underneath nearside front/centre |7.2.3| | 1 |
Front Front position lamp|s| not working x 2 side lights+n/s/f head light |1.1.A.3b| | 1 |
Registration plate issues | 1 |
Anti-roll bar synthetic bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Rear position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Additional braking device leaking oil |3.6.I.6| | 1 |
Nearside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Rear Leaf spring has excessive wear in a shackle pin and/or bush |2.4.B.2| | 1 |
Offside brake caliper has restricted free movement |3.5.1k| | 1 |
Parking brake is not capable of being maintained in operation by direct mechanical action only |3.1.2| | 1 |