>

MOT History from tests of diesel IVECO-FORD MINIBUSs year 2003

Review the list of common IVECO-FORD MINIBUS failures below or to perform a specific mot history check on your IVECO-FORD then use our popular KnowYourCar service

mot history
Pass percent:72.41%
(The average a diesel IVECO-FORD MINIBUS year 2003 passes without issue)
Based on:87 MOT Tests
Most common failuresNo# failures
Registration plate lamp issues6
Brake pipe excessively corroded6
Windscreen wiper does not clear the windscreen effectively5
Headlamp aim out of alignment3
Offside front brake binding |3.7.B.1|2
Offside Rear fog lamp not working |1.3.2b|2
Parking brake: efficiency below requirements |3.7.B.7|2
Offside Rear Anti-roll bar linkage corroded and seriously weakened (5.3.3 (b) (i))1
Offside Front position lamp|s| not working |1.1.A.3b|1
Seat belt locking mechanism does not secure or release |5.2.5a|1
Nearside Front Brake pipe twisted |found during steering lock to lock check| |2.2.D.2b|1
Mechanical brake component has restricted free movement1
Stop lamp|s| all not working |4.3.1 |a| |iii||1
Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Outrigger |7.1.1 |a| |i||1
Speed limiter plate missing |7.10 |e||1
Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Wheel arch outrigger |7.1.1 |a| |i||1
Front brake application uneven1
Rear Exhaust has a major leak of exhaust gases |7.1.2|1
Rear Exhaust system not adequately supported |7.1.1|1
Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2|1
Offside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2|1
Nearside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2|1
Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2|1
Offside Stop lamp not working |1.2.1b|1
Nearside Rear Anti-roll bar pin or bush excessively worn |5.3.4 |a| |i||1
Offside Rear Anti-roll bar pin or bush excessively worn |5.3.4 |a| |i||1
Offside Headlamp aim projected beam image is obviously incorrect |4.1.2 |c||1
Nearside Headlamp aim projected beam image is obviously incorrect |4.1.2 |c||1
Indicator switch inoperative |4.4.2 |a| |ii||1
Nearside Rear Outline marker lamp missing |4.2.1 |a||1
Nearside Outline marker lamp not working centre side marker |4.2.1 |a||1
Offside Front Outline marker lamp not working |4.2.1 |a||1
Offside Rear fog lamp not working |4.5.1 |a| |ii||1
Parking brake efficiency less than 50% of the required value |1.4.2 |a| |ii||1
Nearside Stop lamp not working |1.2.1b|1
Nearside Front Front position lamp|s| not working |1.1.A.3b|1
Nearside Rear Body has a sharp edge caused by damage |6.1.C.1|1
Brake pedal spongy |3.3.B.1b|1
Nearside Rear rear brake excessively fluctuating |3.7.B.3|1
Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))1
Supplementary Restraint System warning lamp indicates a fault |5.4.2|1
Nearside Power steering component|s| leaking |2.3.3b|1
Nearside Headlamp not working on main beam |1.7.5a|1
Offside Headlamp not working on main beam |1.7.5a|1
Offside Rear Statutory seat belt missing |5.1.1|1
Offside Front Seat belt cut causing the fibres to separate |5.1.B.3a|1
Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2|1
Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2|1
Nearside Rear Rear reflector missing |1.5.1a|1
Headlamp switch faulty |1.2.2|1
Front Windscreen wiper not operating automatically when switched on |6.1.1b|1
Front Hazard warning switch missing |1.4.B.1d|1
Offside Front front brake binding |3.7.B.1|1
Brakes imbalanced across an axle1
Nearside Rear Outer Seat belt damaged sufficient to significantly weakened the webbing |5.2.2a|1
Nearside Front Lower Suspension rod ball joint dust cover no longer prevents the ingress of dirt Front Arm Joint (5.3.4 (b) (ii))1
Offside Front Lower Suspension rod ball joint dust cover no longer prevents the ingress of dirt Front ArmJoint (5.3.4 (b) (ii))1
Offside Rear Seat belt locking mechanism does not secure or release |5.2.5a|1
Offside Inner Rear Seat belt locking mechanism does not secure or release |5.2.5a|1
Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6|1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy