Most common failures | No# failures |
---|
Brake pipe excessively corroded | 9 |
Registration plate lamp issues | 7 |
Headlamp aim out of alignment | 4 |
Windscreen wiper does not clear the windscreen effectively | 4 |
Brakes imbalanced across an axle | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
Front brake disc in such a condition that it is seriously weakened | 2 |
Rear parking brake recording little or no effort | 2 |
Windscreen washer not working | 2 |
Parking brake: efficiency below requirements |3.7.C.1b| | 2 |
Nearside Rear Brake pipe leaking |3.6.A.1| | 1 |
Front Windscreen wiper not working (3.4 (a)) | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Offside Front Brake pipe at imminent risk of failure or fracture |1.1.11 |a|| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Battery insecure |1.9.1| | 1 |
Nearside Rear Direction indicator not working |1.4.A.2c| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Shock absorber insecure |2.7.2b| | 1 |
Offside Front Shock absorber insecure |2.7.2b| | 1 |
Nearside Front Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
Nearside Rear Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Offside Rear Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Nearside Front Body component corroded and likely to cause injury step area |6.2.1 |a| |i|| | 1 |
Offside Front Body component corroded and likely to cause injury step area |6.2.1 |a| |i|| | 1 |
Parking brake efficiency less than 50% of the required value |1.4.2 |a| |ii|| | 1 |
Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Horn not working |1.6.2a| | 1 |
Brake fluid warning lamp illuminated |3.6.G.2| | 1 |
Rear brake binding | 1 |
Rear Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Exhaust tailpipe not capable of allowing the emission probe to be inserted |7.4.B.1| | 1 |
Emissions not tested |7.0| | 1 |
Offside All position lamps not working |4.2.1 |a|| | 1 |
Offside Front Direction indicator not working |1.4.A.2c| | 1 |
Front Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Service brake excessively fluctuating (1.2.1 (e)) | 1 |
Nearside Front Service brake grabbing severely (1.2.1 (c)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Nearside Rear Upper Position lamp not working |4.2.1 |a|| | 1 |
Offside Rear Upper Position lamp not working |4.2.1 |a|| | 1 |
Nearside Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Nearside Rear Service brake effort inadequate at a wheel |1.2.1 |a| |i|| | 1 |
Nearside Rear Service brake excessively binding |1.2.1 |f|| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Offside Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Nearside Headlamp light source and lamp not compatible (4.1.4 (c)) | 1 |
Offside Headlamp light source and lamp not compatible (4.1.4 (c)) | 1 |
Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
Nearside Front Position lamp not working |4.2.1 |a|| | 1 |
Offside Front Position lamp not working |4.2.1 |a|| | 1 |
Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Front Body has a sharp edge caused by corrosion both side inner wheel arches rotted |6.1.C.1| | 1 |
Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings both side inner sills rotted and holed |6.1.B.2| | 1 |
Rear Body has a sharp edge caused by corrosion both side inner quarter sill rotted |6.1.C.1| | 1 |
Rear Body has a sharp edge caused by corrosion inner cross member rotted |6.1.C.1| | 1 |
Front Body has a sharp edge caused by corrosion both side inner door steps to inner wheel arches rotted |6.1.C.1| | 1 |