| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 8 |
| Registration plate lamp issues | 4 |
| Anti-lock braking system warning lamp indicates an ABS fault | 3 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 3 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 3 |
| Registration plate issues | 3 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 3 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
| Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 2 |
| Offside front brake binding |3.7.B.1| | 2 |
| Brake pipe excessively corroded | 2 |
| Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 2 |
| Headlamp aim out of alignment | 2 |
| Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Nearside Front Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Offside Front Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 1 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Steering rack gaiter insecure |2.2.D.2d| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill |2.4.A.3| | 1 |
| Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
| rear brake excessively fluctuating |3.7.B.3| | 1 |
| Windscreen wiper blade insecure | 1 |
| Nearside Headlamp aim beam image kick up to the offside |1.8| | 1 |
| Nearside Rear Body has a sharp edge caused by corrosion WHEEL ARCH |6.1.C.1| | 1 |
| Offside Rear Body has a sharp edge caused by corrosion WHEEL ARCH |6.1.C.1| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded SILL/INNER WING PANELS |2.4.A.3| | 1 |
| Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
| Offside Rear fog lamp missing |1.3.2a| | 1 |
| Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 1 |
| Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Centre Exhaust has a major leak of exhaust gases as marked
|7.1.2| | 1 |
| Rear Stop lamp not working |1.2.1b| | 1 |
| Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
| Supplementary Restraint System warning lamp indicates a fault |5.4.2| | 1 |
| Offside Front Position lamp not working |4.2.1 |a|| | 1 |
| Nearside Front Anti-roll bar linkage ball joint excessively worn |5.3.4 |a| |i|| | 1 |
| Nearside Front Wheel bearing rough when rotated |5.1.3 |b| |i|| | 1 |
| Offside Headlamp has a product on the lens so that the light output is severely reduced |4.1.4 |b|| | 1 |
| Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Engine MIL inoperative or indicates a malfunction |8.2.1.2 |h|| | 1 |
| Bonnet retaining device ineffective |8.4.2| | 1 |
| Nearside front brake binding |3.7.B.1| | 1 |