Most common failures | No# failures |
---|
Headlamp aim out of alignment | 7 |
Brake pipe excessively corroded | 7 |
Brake hose excessively deteriorated | 5 |
Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 3 |
Horn not working |1.6.2a| | 2 |
Nearside Side repeater not working |1.4.A.2c| | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Registration plate lamp issues | 2 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Brake pedal spongy |3.3.B.1b| | 1 |
Nearside Headlamp insecure |1.7.3| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Rear Service brake effort inadequate at a wheel n/s/r 210kgf... o/s/r 247kgf... both wheels poor performance |1.2.1 |a| |i|| | 1 |
Rear Rear fog lamp not working o/s/r bad contact,,, |n/s/r bulb rattling in lamp| |4.5.1 |a| |ii|| | 1 |
Driver`s door does not latch securely closed |6.2.3 |a|| | 1 |
Nearside Rear Suspension spring mounting prescribed area is severely distorted |2.4.A.3| | 1 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
Exhaust system insecure |6.1.2 |a|| | 1 |
Nearside Rear Brake pipe excessively damaged axle pipe |1.1.11 |c|| | 1 |
Nearside Rear Service brake excessively binding |1.2.1 |f|| | 1 |
Nearside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Nearside Inner Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Nearside Rear fog lamp emits a light other than red |1.3.2e| | 1 |
Exhaust mounting missing |7.1.1b| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Steering rack gaiter split |2.2.D.2d| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Nearside Rear Brake pipe leaking |3.6.A.1| | 1 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Front Exhaust system not adequately supported |7.1.1| | 1 |
Rear parking brake recording little or no effort | 1 |
Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Exhaust emissions likely to be affected by an exhaust leak |8.2.2.1 |b|| | 1 |
Nearside Rear Position lamp not working wrong bulb or bulb in wrong |4.2.1 |a|| | 1 |
Offside Service brake excessively binding |1.2.1 |f|| | 1 |
Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Front Direction indicators not working |1.4.A.2c| | 1 |
Offside Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Brake pipe inadequately clipped |3.6.B.1| | 1 |
Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Offside Outer Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Nearside Outer Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |