| Most common failures | No# failures |
|---|
| Registration plate issues | 38 |
| Headlamp aim out of alignment | 27 |
| Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 25 |
| Rear reflector on motorcycle missing |1.4.1| | 21 |
| Front position lamp does not illuminate immediately when switched on |1.1.3a| | 11 |
| Front wheel bearings have excessive free play |2.3.5b| | 10 |
| Horn not working |1.7.3a| | 10 |
| Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 9 |
| Registration plate lamp issues | 9 |
| Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 8 |
| Rear wheel bearings have excessive free play |2.4.A.2c| | 6 |
| Headlamp aim beam image kick up to the offside |1.6| | 5 |
| Rear reflector missing (4.8.2 (a) (ii)) | 5 |
| Front Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 4 |
| Horn missing |1.7.1| | 4 |
| Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 4 |
| Rear Rear reflector on motorcycle missing |1.4.1| | 4 |
| Rear Wheel alignment incorrect which adversely affects the handling |2.5.1| | 3 |
| Nearside Handlebar handgrip not secure to handlebars. |2.1.1c| | 3 |
| Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 3 |
| Drive chain excessively tight |6.2.1d| | 3 |
| Front Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 3 |
| Headlamp not working on main beam (4.1.1 (a) (ii)) | 3 |
| Front Drive chain sprocket worn to excess |6.2.1e| | 2 |
| Rear Drive chain sprocket worn to excess |6.2.1e| | 2 |
| Roller brake test Neither brake control achieves an efficiency of 25% |3.3.A2b| | 2 |
| Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2| | 2 |
| Front Wheel spoke excessively loose |4.2.1b| | 2 |
| Rear Drive chain excessively tight |6.2.1d| | 2 |
| Roller brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.A2b| | 2 |
| Front Position lamp not working |4.2.1 |a|| | 2 |
| Rear reflector missing |4.8.2 |a| |ii|| | 2 |
| Rear Wheel spoke excessively loose |4.2.1b| | 2 |
| Front wheel bearings are excessively rough |2.3.5b| | 2 |
| Front Brake disc|s| excessively worn |3.2.A1l| | 2 |
| Stop lamp not working |4.3.1 |a| |ii|| | 2 |
| Locking device|s| not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 2 |
| All position lamps do not illuminate immediately when switched on |1.1.3a| | 2 |
| Rear Wheel bearing has excessive play (5.1.3 (a) (i)) | 2 |
| Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 2 |
| Front position lamp missing |1.1.1a| | 1 |
| Front Brake disc|s| has excessive run out |3.2.A1m| | 1 |
| Front Decelerometer brake test indicates a severely grabbing brake |3.3.E1e| | 1 |
| Rear Roller brake test indicates a binding brake |3.3.A1a| | 1 |
| Headlamp aim so that beam "kick up" is not visible on the screen non compatable lamp fitted |4.1.2 |a|| | 1 |
| Drive chain so loose it is likely to fail |6.1.7 |c| |ii|| | 1 |
| Brake lever insecure |3.1.2a| | 1 |
| Brake performance not tested |3.3| | 1 |
| An item not tested |Manual| | 1 |
| Roller brake test No brake control achieves an efficiency of 30%. |3.3.A2a| | 1 |
| Rear Exhaust has part of the system missing |7.1.1a| | 1 |
| Throttle operating incorrectly |6.2.1f| | 1 |
| Front Stop lamp remains on when the brake is released |1.3.1e| | 1 |
| Rear Drive chain worn to excess |6.2.1e| | 1 |
| Rear Motorcycle structure cracked |6.1.1a| | 1 |
| Rear Rear wheel bearings are excessively tight |2.4.A.2c| | 1 |
| Handlebar deformed |2.1.1b| | 1 |
| Front Brake cylinder insecurely mounted |3.2.B1a| | 1 |
| Front Wheel alignment incorrect which adversely affects the handling |2.5.1| | 1 |
| Headlamp light intensity severely reduced |4.1.4 |a|| | 1 |
| Headlamp aim not tested |4.1.2 |b|| | 1 |
| Horn not working |7.7 |a| |ii|| | 1 |
| Horn control not functioning. |1.7.2b| | 1 |
| Direction indicators affected by the operation of another lamp |1.5.1c| | 1 |
| Rear Position lamp not working |4.2.1 |a|| | 1 |
| Nearside Front Direction indicator not working |4.4.1 |a| |ii|| | 1 |
| Front Front wheel bearings have excessive free play |2.3.5b| | 1 |
| Rear Brake disc|s| cracked |3.2.A1g| | 1 |
| Exhaust mounting missing |7.1.1c| | 1 |
| Front Horn not working |1.7.3a| | 1 |
| Stop lamp affected by the operation of another lamp |1.3.2| | 1 |
| Rear Direction indicators affected by the operation of another lamp |1.5.1c| | 1 |
| Rear Rear position lamp adversely affected by the operation of another lamp |1.1.3b| | 1 |
| Front shock absorber seal failed and leaking oil L/H |2.3.3| | 1 |
| Front position lamp does not illuminate immediately when switched on Dip beam. |1.1.3a| | 1 |
| Rear position lamp adversely affected by the operation of another lamp |1.1.3b| | 1 |
| Front Brake fluid contaminated |1.8 |a|| | 1 |
| Rear Brake fluid significantly below minimum mark |1.1.10 |d| |ii|| | 1 |
| Headlamp aim not tested And all electrical equipment unable to run engine |4.1.2 |b|| | 1 |
| Headlamp switch insecure |1.2.4| | 1 |
| Front Hydraulic brake control creeps under load. |3.1.4a| | 1 |
| Centre Front Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 1 |
| Centre Front Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
| Centre Rear Rear reflector on motorcycle missing |1.4.1| | 1 |
| Indicator switch does not operate the direction indicators on the side selected |1.5.4| | 1 |
| Front Brake lever has inadequate reserve travel |3.1.3b| | 1 |
| Exhaust markings indicating not for road use or similar wording |7.1.4| | 1 |
| Rear Brake pedal cannot be released smoothly |3.1.3d| | 1 |
| Rear Floor brake test indicates a binding brake |3.3.C2c| | 1 |
| Steering movement excessively `notchy` with the wheel raised |2.2.1b| | 1 |
| Front Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
| Rear Brake component has restricted free movement and operation is likely to be impeded |3.2.A1h| | 1 |
| Front Wheel has an excessively distorted bead rim. |4.2.2| | 1 |
| Rear reflector on motorcycle obscured |1.4.1| | 1 |
| Rear Brake reaction bracket insecure |3.2.A1j| | 1 |
| Rear Rear wheel bearings have excessive free play |2.4.A.2c| | 1 |
| Drive chain excessively loose |6.2.1d| | 1 |
| Nearside Front Direction indicator missing |1.5.1a| | 1 |
| Nearside Rear Direction indicator missing |1.5.1a| | 1 |
| Offside Rear Direction indicator missing |1.5.1a| | 1 |
| Offside Front Direction indicator missing |1.5.1a| | 1 |
| Drive chain worn to excess |6.2.1e| | 1 |
| Front Direction indicator not working |1.5.1c| | 1 |
| Rear Brake fluid reservoir fluid level dangerously low |3.2.B1d| | 1 |
| Steering headbearing has excessive free play |2.2.2| | 1 |
| Front Floor brake test indicates a sticking brake |3.3.C2c| | 1 |
| Floor brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.C1b| | 1 |
| Rear Drive chain excessively loose (6.1.7 (c) (i)) | 1 |
| Stop lamp not working (4.3.1 (a) (ii)) | 1 |
| Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
| Offside Front Shock absorber has a serious fluid leak (5.3.2 (b)) | 1 |
| Front Wheel spindle loose (5.2.1 (c) (i)) | 1 |
| Offside Front Brake master cylinder insecure (1.1.10 (c)) | 1 |
| Front Position lamp missing (4.2.1 (a)) | 1 |
| Fuel tank leaking carb (6.1.3 (b) (i)) | 1 |
| Rear Brake excessively binding (1.2.1 (f)) | 1 |
| Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Offside Front Wheel fractured crack on alloy rim (5.2.2 (a)) | 1 |
| Offside Front Wheel spoke excessively loose (5.2.2 (d)) | 1 |
| Rear Position lamp not working (4.2.1 (a)) | 1 |
| Handlebar grip insecure to handlebar (2.2.1 (d) (ii)) | 1 |
| Headlamp aim unable to be tested stuck on full beam (4.1.2 (b)) | 1 |
| Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) | 1 |
| Front Position lamp not working (4.2.1 (a)) | 1 |
| Headlamp not working on dipped beam stuck on full beam (4.1.1 (a) (ii)) | 1 |
| All direction indicators missing (4.4.1 (a) (ii)) | 1 |
| Dipswitch does not operate immediately when selected on dipped beam (4.1.3 (b)) | 1 |
| Front Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) | 1 |
| Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b)) | 1 |
| Drive chain excessively tight (6.1.7 (k) (i)) | 1 |
| Drive chain horseshoe locking device likely to become detached (6.1.7 (j) (ii)) | 1 |
| Stop lamp adversely affected by the operation of another lamp not working with side lights on (4.3.3 (b)) | 1 |
| Dipswitch does not operate immediately when selected on main beam (4.1.3 (b)) | 1 |
| Horn not working (7.7 (a)) | 1 |
| Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| All direction indicators missing NONE FITTED (4.4.1 (a) (ii)) | 1 |