Most common failures | No# failures |
---|
Registration plate issues | 12 |
Rear reflector on motorcycle missing |1.4.1| | 4 |
Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 4 |
Headlamp aim out of alignment | 4 |
Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 2 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 2 |
Headlamp aim beam image kick up to the offside |1.6| | 2 |
Horn not working (7.7 (a)) | 2 |
Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 2 |
Throttle operating incorrectly |6.2.1f| | 2 |
Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) | 1 |
All direction indicators not working (4.4.1 (a) (ii)) | 1 |
Nearside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a)) | 1 |
Front Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Front Brake fluid reservoir fluid level dangerously low |3.2.B1d| | 1 |
Handlebar mounting clamp loose |2.1.1a| | 1 |
Rear Rear shock absorber has inadequate damping effect. (2.4.A.3b) | 1 |
Throttle has a significant change in engine speed whilst moving the steering from lock to lock (2.1.4) | 1 |
Steering operation fouling on the fuel tank or bodywork on full lock on r/h lock against spot lamp (2.1.4 (b)) | 1 |
Offside Headlamp insecure spot lamp (4.1.1 (c)) | 1 |
Headlamp aim projected beam image obviously incorrect kick up to the right (4.1.2 (c)) | 1 |
Handlebar mounting clamp bolt loose |2.1.1a| | 1 |
Rear Valve stem seriously damaged (5.2.3 (j)) | 1 |
Offside Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Front Stop lamp not working (4.3.1 (a) (ii)) | 1 |
Riders seat insecure (6.2.5 (a) (ii)) | 1 |
Front Headlamp aim beam image kick up to the offside |1.6| | 1 |
Rear Rear reflector on motorcycle missing |1.4.1| | 1 |
Rear An item not tested |Manual| | 1 |
Locking devices not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 1 |
Nearside Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
Front position lamp does not illuminate immediately when switched on |1.1.3a| | 1 |
Direction indicators not working |1.5.1c| | 1 |
Direction indicators affected by the operation of another lamp |1.5.1c| | 1 |
Front Roller brake test indicates a binding brake |3.3.A1a| | 1 |
Front An item not tested |Manual| | 1 |
Rear Brake lever has inadequate reserve travel |3.1.3b| | 1 |
Stop lamp missing |1.3.3a| | 1 |
Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 1 |
Nearside Front Direction indicator insecure |1.5.3b| | 1 |
Steering control handlebar movement restricted by cables caught on a projection |2.1.2c| | 1 |
Steering control fouling between components which interferes with the free movement of the steering |2.1.2a| | 1 |
Decelerometer brake test the less effective brake control does not achieve an efficiency of 25%. |3.3.E1b| | 1 |
Centre Headlamp aim beam image kick up to the offside |1.8| | 1 |
Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Steering headbearing has excessive free play |2.2.2| | 1 |
Rear Stop lamp switch with a delay in operation (4.3.2 (a) (ii)) | 1 |
Rear shock absorber has inadequate damping effect. both rear dampers bottoming out |2.4.A.3b| | 1 |
Rear Stop lamp emits other than a steady red light |1.3.1b| | 1 |