>

MOT History from tests of petrol HONDA LOGOs year 2001

Review the list of common HONDA LOGO failures below or to perform a specific mot history check on your HONDA then use our popular KnowYourCar service

mot history
Pass percent:71.63%
(The average a petrol HONDA LOGO year 2001 passes without issue)
Based on:289 MOT Tests
Most common failuresNo# failures
Windscreen wiper does not clear the windscreen effectively21
Headlamp aim out of alignment17
Brake pipe excessively corroded11
Nearside Stop lamp not working |1.2.1b|5
Offside Stop lamp not working |1.2.1b|5
Registration plate lamp issues3
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b|3
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3|3
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3|3
Rear fog lamp not working |1.3.2b|3
Offside Rear fog lamp not working |1.3.2b|3
Offside Rear Stop lamp not working |1.2.1b|2
Anti-lock braking system warning lamp indicates an ABS fault2
Nearside Front Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2|2
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e|2
Offside Front Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2|2
Centre Exhaust system not adequately supported |7.1.1|2
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3|2
Offside Front Driver`s airbag obviously defective |5.4.1|1
Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))1
Offside Headlamp has a product on the light source so that the light output is severely reduced (4.1.4 (b))1
Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL (5.3.6 (a) (i))1
Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength ARCH (5.3.6 (a) (i))1
Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL (5.3.6 (a) (i))1
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength ARCH (5.3.6 (a) (i))1
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))1
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))1
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))1
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))1
Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))1
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b|1
Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a|1
Nearside Front Lower Suspension arm inappropriately repaired |2.4.A.2|1
Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings offside rear outer sill |6.1.B.2|1
Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a|1
Nearside Front Suspension arm has excessive play in a ball joint |2.4.G.2|1
Nearside Front Suspension arm inappropriately repaired bottom ball joint welded |2.4.A.2|1
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2|1
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2|1
Nearside Headlamp aim beam image kick up to the offside |1.8|1
Offside Headlamp aim beam image kick up to the offside |1.8|1
Offside Rear fog lamp missing |1.3.2a|1
Rear Exhaust system not adequately supported |7.1.1|1
Emissions not tested |7.3.A.1|1
Rear Exhaust has a major leak of exhaust gases |7.1.2|1
Offside Track rod end ball joint has excessive play |2.2.B.1f|1
Rear Rear fog lamp missing |1.3.2a|1
Nearside Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c|1
Offside Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c|1
Nearside Front Headlamp not working on main beam |4.1.1 |a| |ii||1
Offside Rear Rear fog lamp not working |4.5.1 |a| |ii||1
Headlamp aim projected beam image is obviously incorrect Nearside + Offside (4.1.2 (c))1
Offside Front Service brake excessively binding (1.2.1 (f))1
Central Stop lamp|s| not working |4.3.1 |a| |ii||1
Offside Front position lamp|s| not working side light |1.1.A.3b|1
Offside Obligatory mirror missing mirror |8.1.1|1
Offside Rear Outer Seat belt anchorage prescribed area is excessively corroded sill |5.2.6|1
Nearside Track rod end ball joint has excessive play |2.2.B.1f|1
Brakes imbalanced across an axle1
Nearside Front Position lamp not working (4.2.1 (a) (ii))1
Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))1
Nearside Stop lamp|s| not working |4.3.1 |a| |ii||1
Offside Stop lamp|s| not working |4.3.1 |a| |ii||1
Stop lamp(s) all not working (4.3.1 (a) (iii))1
Nearside Windscreen wiper blade deteriorated |8.2.2|1
Offside Windscreen wiper blade deteriorated |8.2.2|1
Nearside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6|1
Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6|1
Offside Rear Body has a sharp edge caused by damage |6.1.C.1|1
Offside Rear Seat belt anchorage prescribed area is excessively corroded Sill |5.2.6|1
Nearside Rear Seat belt anchorage prescribed area is excessively corroded Sill |5.2.6|1
Nearside Front Seat belt anchorage prescribed area is excessively corroded Sill |5.2.6|1
Registration plate issues1
Centre Stop lamp not working |1.2.1b|1
Offside Front Headlamp not working on dipped beam |1.7.5a|1
Central Rear Upper Stop lamp not working |1.2.1b|1
Offside Obligatory mirror seriously obscured affecting the rear view |8.1.2a|1
Nearside Front Road wheel bead rim badly distorted |4.2.A.1a|1
Nearside Rear Road wheel bead rim badly distorted |4.2.A.1a|1
Nearside Front Anti-roll bar linkage has excessive play in a ball joint drop link |2.4.G.2|1
Offside Front Anti-roll bar linkage has excessive play in a ball joint drop link |2.4.G.2|1
Headlamp lens seriously defective offside+nearside |4.1.1 |b| |ii||1
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4|1
Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3|1
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3|1
Rear fog lamp not working (4.5.1 (a) (ii))1
Nearside Stop lamp(s) not working (4.3.1 (a) (ii))1
Nearside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c|1
Nearside Front suspension has excessive movement at a wishbone pin or bush |2.5.A.1c|1
Brake performance not tested |3.7.A.1|1
Service brake: efficiency below requirements |3.7.B.7|1
Parking brake: efficiency below requirements |3.7.B.7|1
Brake master cylinder fluid level below minimum level |3.6.G.1e|1
Engine MIL inoperative or indicates a malfunction |8.2.1.2 |h||1
Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced Outer sill corroded. |7.1.1 |a| |i||1
Nearside Headlamp has a product on the lens so that the light output is severely reduced |1.7.5a|1
Nearside Rear Suspension component mounting prescribed area is excessively corroded Sill |2.4.A.3|1
Nearside Rear Valve stem seriously misaligned |4.1.D.1e|1
Exhaust has a major leak of exhaust gases rear box |7.1.2|1
Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3|1
Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3|1
Offside Rear Suspension component mounting prescribed area is excessively corroded sill end/arch area |2.4.A.3|1
Offside Front position lamp|s| not working |1.1.A.3b|1
Upper Stop lamp not working |1.2.1b|1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy