>

MOT History from tests of petrol HONDA INTEGRAs year 2009

Review the list of common HONDA INTEGRA failures below or to perform a specific mot history check on your HONDA then use our popular KnowYourCar service

mot history
Pass percent:79.83%
(The average a petrol HONDA INTEGRA year 2009 passes without issue)
Based on:119 MOT Tests
Most common failuresNo# failures
Parking brake efficiency below requirements (1.4.2 (a) (i))5
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))4
Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))4
Registration plate issues4
Brakes imbalanced across an axle3
Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a))3
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a))3
Headlamp aim out of alignment3
Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))3
Nearside Front Road wheel fixing missing (5.2.1 (a) (i))2
Windscreen wiper does not clear the windscreen effectively2
Brake pipe excessively corroded2
Offside Front Road wheel fixing missing (5.2.1 (a) (i))2
Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))2
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))2
Exhaust carbon monoxide content at idle exceeds manufacturers specified limits (8.2.1.2 (b))2
Nearside Rear Parking brake inoperative on one side (1.4.1 (a))2
Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))2
Offside Rear Service brake excessively fluctuating (1.2.1 (e))1
Offside Parking brake inoperative on one side (1.4.1 (a))1
Offside Front Coil spring fractured or broken (5.3.1 (b) (i))1
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))1
Fuel hose leaking (6.1.3 (b) (i))1
Windscreen washer not working 1
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))1
Nearside Front Anti-roll bar linkage ball joint likely to become detached (5.3.4 (a) (ii))1
Front Exhaust has a major leak of exhaust gases (6.1.2 (a))1
Exhaust hydrocarbon content after 2nd fast idle exceeds default limits |8.2.1.2 |b||1
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits |8.2.1.2 |b||1
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))1
Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))1
Brake lever has insufficient reserve travel //hand brake // |1.1.2 |a||1
Nearside Front Ball joint has excessive play |2.2.B.1f|1
Nearside Stop lamp(s) not working (4.3.1 (a) (ii))1
Rear brake disc in such a condition that it is seriously weakened1
Emissions not tested (8.2.1.2 (d))1
Headlamp aim unable to be tested (4.1.2 (b))1
All direction indicators not working (4.4.1 (a) (ii))1
Rear fog lamp missing (4.5.1 (a) (ii))1
Service brake efficiency below requirements (1.2.2 (a) (i))1
Offside Front Position lamp not working (4.2.1 (a) (ii))1
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))1
Offside Front Lower Suspension component ball joint likely to become detached loose in housing (5.3.4 (a) (ii))1
Offside Front Hydraulic brake calliper leaking and braking performance affected (1.1.16 (b) (ii))1
Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))1
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))1
Offside Front Headlamp levelling device cannot be operated from the drivers seat (4.1.5 (b))1
Front Headlamp levelling device inoperative (4.1.5 (a))1
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))1
Offside Front Power steering pipe/hose excessively corroded (2.1.5 (g) (i))1
Offside Front Lower Suspension locking device missing ball joint (5.3.6 (b))1
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))1
Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill corroded and holed (7.1.1 (a) (i))1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy