| Most common failures | No# failures |
|---|
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 7 |
| Parking brake: efficiency below requirements |3.7.B.7| | 6 |
| Headlamp aim out of alignment | 6 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 6 |
| Registration plate lamp issues | 5 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 5 |
| Rear parking brake recording little or no effort | 5 |
| Brake pipe excessively corroded | 5 |
| Windscreen wiper does not clear the windscreen effectively | 4 |
| Front Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 3 |
| Registration plate issues | 2 |
| Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
| Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 2 |
| Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Service brake: efficiency below requirements |3.7.B.7| | 2 |
| Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Direction indicator not working |1.4.A.2c| | 1 |
| Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Offside Front Brake back plate|s| securing device excessively deteriorated |3.5.1j| | 1 |
| Offside Front Seat belt damaged sufficient to obstruct correct operation of the belt |5.2.2a| | 1 |
| Parking brake lever has no reserve travel |3.1.6b| | 1 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Centre Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Front Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
| Windscreen has damage | 1 |
| Offside Front Direction indicator not working |1.4.A.2c| | 1 |
| Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Nearside Front Anti-roll bar linkage rubber bush bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Brakes imbalanced across an axle | 1 |
| Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Front Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Nearside Front Anti-roll bar linkage cracked |2.4.G.1| | 1 |
| Nearside Front Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
| Stop lamp not working |1.2.1b| | 1 |
| Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Brake hose has insufficient room to move | 1 |
| rear brake recording little or no effort |3.7.B.5a| | 1 |
| Nearside Inner Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Lower Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Hazard warning switch faulty |1.4.B.1d| | 1 |
| Offside Headlamp aim beam image too far to the right |1.6.B4| | 1 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Nearside Front Direction indicator incomplete |1.5.A1b| | 1 |
| Offside Rear Stop lamp not working |1.2.1b| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Front Headlamp not in a clean condition affecting beam image |1.2.4a| | 1 |
| Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
| Centre Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Anti-roll bar linkage fractured |2.4.G.1| | 1 |
| Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
| Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Battery insecure |1.9.1| | 1 |
| Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Rear Statutory seat belt missing |5.1.1| | 1 |
| Nearside Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
| Offside Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
| Front Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Offside Rear Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Front Headlamp aim beam image kick up to the offside |1.6.B1| | 1 |
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |