Most common failures | No# failures |
---|
Registration plate issues | 8 |
Headlamp aim out of alignment | 6 |
Drive chain excessively loose |6.2.1d| | 3 |
Rear reflector on motorcycle missing |1.4.1| | 3 |
Throttle operating incorrectly |6.2.1f| | 3 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 2 |
Steering movement excessively `notchy` with the wheel raised |2.2.1b| | 2 |
Steering headbearing has excessive wear or free play (2.2.2 (f) (i)) | 1 |
Front Stop lamp not working Replaced front brake light switch |4.3.1 |a| |ii|| | 1 |
Steering operation fouling on the fuel tank or bodywork on full lock Temporary repair carried out. Will need repairing properly. (2.1.4 (b)) | 1 |
All direction indicators adversely affected by the operation of another lamp (4.4.3 (b)) | 1 |
Offside Front Brake caliper insecurely mounted and braking performance affected (1.1.16 (c) (ii)) | 1 |
Brake performance not tested (1.2.1 (g)) | 1 |
Front suspension assembly component excessively bent |2.3.1| | 1 |
Offside Front Direction indicators not working |1.5.1c| | 1 |
Front Shock absorber has a serious fluid leak (5.3.2 (b)) | 1 |
Front Roller brake test indicates a binding brake |3.3.A1a| | 1 |
Front Stop lamp not working off front brake |4.3.1 |a| |ii|| | 1 |
Brake pedal is bent and the brake cannot be readily applied |1.1.2 |d|| | 1 |
Brake fluid significantly below minimum mark |1.1.10 |d| |ii|| | 1 |
Nearside Rear Footrest insecure |6.2.12 |a|| | 1 |
Roller brake test No brake control achieves an efficiency of 30% |1.2.2 |a| |i|| | 1 |
Front Stop lamp not working |4.3.1 |a| |ii|| | 1 |
Front Brake fluid reservoir fluid level significantly below minimum level |1.1.10 |d| |ii|| | 1 |
Steering movement excessively `notchy` with the weight on the lower bearing |2.2.1a| | 1 |
Locking devices not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 1 |
Offside Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Offside Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 1 |
Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Throttle has a significant change in engine speed whilst moving the steering from lock to lock |2.1.4| | 1 |
Stop lamp affected by the operation of another lamp |1.3.2| | 1 |
Stop lamp insecure |1.3.3b| | 1 |
Horn not working (7.7 (a)) | 1 |
Nearside Rear Direction indicator not working (4.4.1 (a) (ii)) | 1 |
Rear Stop lamp not working (4.3.1 (a) (ii)) | 1 |
Throttle control functioning such that safe operation of the motorcycle is adversely affected Throttle sticking on full lock (6.2.7 (a) (ii)) | 1 |
Rear Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) | 1 |
Rear Chain guard insecure (6.1.7 (i)) | 1 |
Rear Brake hose damaged and likely to fail Brake hose bracket snapped allowing brake hose to fall into very close contact with rear wheel (1.1.12 (a)) | 1 |
Headlamp aim projected beam image obviously incorrect (4.1.2 (c)) | 1 |
Drive chain worn to excess |6.2.1e| | 1 |
Front Steering headbearing excessively stiff or notchy |2.2.2 |f| |i|| | 1 |
Registration plate lamp issues | 1 |
Rear Direction indicator obviously incorrectly positioned (4.4.3 (a)) | 1 |
Rear reflector missing (4.8.2 (a) (ii)) | 1 |
Front Position lamp not working (4.2.1 (a)) | 1 |
Front Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
Front Front position lamp incorrect colour |1.1.2a| | 1 |
Front Steering movement excessively `notchy` with the wheel raised |2.2.1b| | 1 |
Drive chain excessively tight |6.2.1d| | 1 |
Front Stop lamp not working (4.3.1 (a) (ii)) | 1 |
Offside Front Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Stop lamp does not illuminate immediately a brake applies control 1, front brake lever |1.3.1a| | 1 |
Front Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) | 1 |